Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-36
38 1,2 Protocol monitor Used to set whether the protocol monitor (which is recognized by the FAX) for one
communication is printed or not.
When a new communication is made before printing the protocol monitor, the old
protocol data are deleted. (Overwriting)
0NO
0
3 Line monitor display Used to set whether the communication speed during communication and the
reception level during reception are displayed on the LCD or not.
0Not
displayed
4-8 Time print (o'clock) on
the communication
report table
Used to set the time print (o'clock) when time is printed on the communication
report table. The set range is 0 - 24 o'clock by binary input. If a value of 24 - 31 is
inputted, it is set to 0 o'clock.
0 1 o'clock Initial setup
0
0
0
1
39 1 Communication report
table printing at the
specified time
Used to set whether the communication report table is outputted at the specified
time or not.
Though time specification print is enabled, if the specified time is in the nighttime
FAX mode, output is not made.
0 Not output Initial setup
2-7 Time print (min) on the
communication report
table
Used to set the time print (min) when time is printed on the communication report
table.
The set range is 0 - 59min by binary input. If a value of 60 - 63 is inputted, it is set
to 0 min.
0 1 min Initial setup
0
0
0
0
1
8 Automatic print of
communication report
table at memory full
Used to set whether the communication report table is automatically outputted or
not when the number of send/receive items reaches 50 items.
If the report is not outputted, the oldest data are overwritten.
0 Not output Initial setup
40 1 Print of total
communication time on
the communication
report table
Used to set whether the total communication time and the total number of pages
are printed on the communication report table or not.
0Print
2 Transmitted document
content print in memory
transmission error
Used to set whether some part of the transmitted document is printed on the
communication report table (transmission) in case of memory transmission error.
0 Print Initial setup
3 Not used 0
4 Report output
(When canceling)
Used to set whether the communication report table is outputted or not when
transmission is canceled during transmission of document.
0 Not output
5 Report output setup
(in confidential
reception)
Used to set whether the communication report table (reception) is outputted or not
in confidential reception.
0 Output Initial setup
6,7 Not used 0
1
8 Department
management
Used to set whether department management is performed or not. When
department management is performed, the management of number of pages in
made only for FAX transmission.
0NO
SW
No.
Bit
No.
Item Switch selection and function Initial value
Key
operator
Bit No. 1 2
NO (Not print) 0 0
NO (Not print) 0 1
Print (Always) 1 0
Only in an error (Print) 1 1
1: Displayed on LCD 0: Not displayed on LCD
1: Communication report table is
printed at the specified time.
0: Communication report table is not
printed at the specified time.
1: Automatic print 0: Not print
1: Not print 0: The total time and the total number of
pages are printed.
1: Transmitted document is not printed. 0: Transmitted document is printed.
1: Communication report table is
printed.
0: Communication report table is not
printed.
1: Communication report table is not
printed.
0: Communication report table is
printed.
1: YES 0: NO