Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-31
23 1 EOL detection timer Used to set the detection timer (sec) of EOL (End Of Line) in Phase C reception of
G3 mode.
If an error occurs in EOL detection, it is processed as EOL not detected.
0 13sec
2 Polarity reversion
monitor during
transmission
Used to set whether polarity reversion is monitored on the dial calling side or not
during transmission.
Functions only in Japan.
0Monitor
3 Polarity reversion is
monitored during calling
Used to set whether polarity reversion is monitored or not when dial calling.
Functions only in Japan.
0Monitor
4-6 Not used 0
0
1
7,8 RTN send line error rate Used to set the threshold value for judgment of RTN sending in G3 reception. The
threshold value is of STD conversion. The half of this value is used for judgment of
RTP sending.
When, for example, FINE is received, the threshold value is doubled.
1 60 lines
0
24 1 DCS-TCF interval time Used to set the time interval (sec) from DCS sending to TCF signal sending.
The ITU-T standard is 75 ± 20ms.
0 75msec
2 EQM judgment
threshold value
when confirming TCF
reception
Used to set whether the threshold value (FTT) is set severely or loosely for EQM
judgment in confirmation of TCF reception.
If set loosely, TCF is easy to return CFR, but apt to cause an error in PIX (Phase
C).
0 Severely
3 Judgment method in
confirmation of TCF
reception
Used to set the judgment method of FTT in confirmation of TCF reception. 0 0
4,5 Not used 0
0
6 CED signal send Used to set whether CED signal is sent or not.
Valid only when SW43.1 (V.34 mode function ) is OFF.
This is because ANSam signal is indispensable in V.34 mode.
0Send
7,8 CED signal send time Used to set the time for CED signal send. ANSam signal follows SW46-7 ~ 8. 0 3sec
0
SW
No.
Bit
No.
Item Switch selection and function Initial value
Key
operator
1: 25sec 0: 13sec
1: Polarity reversion is not monitored. 0: Polarity reversion is monitored.
1: Polarity reversion is not monitored. 0: Polarity reversion is monitored.
Bit No. 7 8
6 liens 0 0
9 lines 0 1
60 lines 1 0
120 lines 1 1
1: 150msec 0: 75msec
1: Loosely 0: Severely
1: Judged by EQM value. TCF is
checked loosely.
0: Received data is judged to be 0 or
not, and EQM value is judged.
1:CED signal is not sent. 0:CED signal is sent.
Bit No. 7 8
3sec 0 0
4sec 0 1
5sec 1 0
6sec 1 1