Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-30
19 1-8 Not used 0
0
0
0
0
0
0
0
20 1 CSI send Used to set whether CSI send is performed or not.
The CSI signal includes the sender's number.
0 Send
2 DIS reception
confirmation in G3
transmission
Used to set whether DIS reception is conformed or not in G3 mode transmission
(valid only in other than V.34). This is valid only when communication is made in
other then V.34.
00
3,4 Timer setup between
flag and address
(V.21-FSK)
Used to set the timer between Flag and address when receiving FSK signal in a
communication other than V.34.
0 6sec
0
5 Not used 0
6 Countermeasures
against echo in
reception
(CED tone send interval)
Used to set the time interval (sec) from sending CED or ANSam to sending FSK
signal of DIS.
If either SW20-6 or SW2-7 is YES, disconnection of the line after completion of
communication is delayed for 1.5sec.
0 75msec
7 Countermeasures
against echo in
transmission
(Used to set the hold
time from DIS reception
to signal sending.)
Used to set the time interval (sec) from DIS reception to DCS signal sending.
This is valid only in the mode other than V.34.
If either SW20-6 or SW2-7 is YES, disconnection of the line after completion of
communication is delayed for 1.5sec.
0 200msec
8 Not used 0
21 1-3 Setup of call time in auto
transmission
(T0 timer setup)
Used to set the time (sec) of calling when the other party does not receive the call
in automatic transmission.
The set range if 30 - 60sec in the increment of 5sec by binary input of N into "(5sec
x N) + 30sec." N is of 0 - 7. When N is set to 7 (setup to 65sec), it is the same as
setup to 45sec.
0 45sec Send setup
1
1
4-7 T1timer setup Used to set the time (sec) for disconnection of line when the other party does not
respond in FAX communication. The set range is 30 - 105sec in the increment of
5sec by binary input of N into "(5sec x N) + 30sec." N is set in the range of 0 - 15.
T1 timer is the timer for the time from recognition of FAX CED or DCS) by the other
party after connection of line. The ITU-T standard is 35 ± 5sec.
0 40sec
0
1
0
8 Not used 0
22 1-4 Not used 0
0
0
0
5,6 T4 timer setup at auto
mode
(+1.5sec for manual)
Used to set the timer up to respond and receive.
Timer for DCS signal to respond and receive. For the ITU-T standard, 3sec ± 15%.
0 3sec
0
7,8 Not used 0
0
SW
No.
Bit
No.
Item Switch selection and function Initial value
Key
operator
1:CSI signal not send 0:CSI signal send
1: Reception of DIS is checked
twice.
0: Reception of NSF/DIS is checked once,
reception without NSF is check twice.
Bit No. 3 4
6sec 0 0
15sec 0 1
30sec 1 0
120sec 1 1
1: 500msec 0: 75msec
1: 500msec 0: 200msec
Bit No. 5 6
3sec 0 0
4sec 0 1
5sec 1 0
6sec 1 1