Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-28
10 1-4 Ring back tone ON time Used to set ring back tone ON time to pseudo-ringing to external telephone and
the line.
Can be set in the range of 0sec - 3sec in 200ms increment by binary input.
When, however, set to 0sec, it is the same as when set to 1.
0 1 sec
1
0
1
5-8 Ring back tone OFF
time
Used to set ring back tone OFF time to pseudo-ringing to external telephone and
the line.
Can be set in the range of 0sec - 3sec in 200ms increment by binary input.
When, however, set to 0sec, it is the same as when set to 2sec.
When set to less than 2sec, the busy tone may be erroneously detected.
1 2 sec
0
1
0
11 1-4 Not used 0
0
0
0
5 Automatic wake up
mode
Used to set whether the machine is automatically wake up and the received
document is outputted or the received document is saved in memory and will be
outputted when the power is turned on next time when a FAX message is received
with the main SW ON and the FAX power SW ON or in the power save mode.
0 Output Initial setup
6,7 Not used 0
0
8 Selection of resend
page in case of an error
Used to select resend pages in case of an error in transmission without F code.
If transmission includes F code, all pages are resent.
0 After the
error page
12 1-8 External telephone hook
detection time
Used to set the time to recognize external telephone off-hook detection.
The set range is 0ms - 2550ms in the increment of 10ms by binary input.
0 300ms
0
0
1
1
1
1
0
13 1-8 Remote switch number
setup
Used to set the number for remote switch reception from an external telephone by
binary input. "XX*" and "*" in the remote switch number are fixed.
0 5* Initial setup
1
0
1
1
0
1
0
14 1 Remote reception
instruction
Used to set YES/NO of remote switch from an external telephone. 0 YES
2 Notification to external
telephone in remote
switch
Used to set whether an alarm notification is sent to the external telephone or not
when remote switch from an external telephone is performed.
0YES
3 Remote switch
operation allowed
Used to set whether remote switch from an external telephone is allowed only
when receiving or when sending and receiving.
For North America, remote switch is allowed even in standby state.
For north America, this switch is disabled.
0 Only when
receiving
4-8 Not used 0
0
0
0
0
SW
No.
Bit
No.
Item Switch selection and function Initial value
Key
operator
1: Saved in memory without booting
machine
0: Output by automatic booting of
machine
1: All pages (Resend all pages from the first
page including transmitted pages.)
0: After error page
(Resend after error page)
Bit No 1234 5678
0101 1010
2nd
digit
1st
digit
1: NO (remote switch disable) 0: YES (Remote switch enable)
1: NO (Not notify) 0: YES(Notify)
1: Switch enable in call ring/reception
ring
0: Switch enable only in reception ring