Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-26
6 1-3 Image priority selection
(Standard resolution
setup)
Used to set the initial setup in image selection when scanning document.
When set to 100, the operation is the same as Normal.
0 Standard Operation
setup
0
0
4 Automatic reduction
send
Used to set whether the transmitted document is reduced or the both ends are cut
when the transmitted document size is greater than the recording paper size
(width) in the other party's machine.
0 Reduction
setup
Send setup
5 Rotation send selection
(A4 A4R)
(LTR LTR-R)
Used to set whether A4 document is transmitted in A3 width (A4) or A4 document
is rotated and transmitted in A4R.
0 Rotate Send setup
6 Rotation send selection
(B5R B5)
Used to set whether B5R document is transmitted in A4 width (B6R) or the scan
image is rotated and transmitted in B4 width (B5).
0 Rotate Send setup
7 Rotation send selection
(A5R A5)
(INVOICE-R
INVOICE)
Used to set whether A5R document is transmitted to A4 width (A5R) or the scan
image is rotated and transmitted in A4 width (A5).
0 Rotate Send setup
8 EEPROM access inhibit When an access trouble to EEPROM in the modem controller occurs, FAX
operation cannot be performed. When this item is set to INHIBIT, FAX operation
can be performed.
The modem controller adjustment values (part of soft switch) are saved in
EEPROM.
ALLOW or INIHIBIT of access to EEPROM is set.
0 Access
allowed
SW
No.
Bit
No.
Item Switch selection and function Initial value
Key
operator
Bit No. 1 2 3
Standard 0 (1) 0 0
Fine 0 0 1
Super fine 0 1 0
Ultra fine 0 1 1
Fine, half tone 1 0 1
Super fine, half tone 1 1 0
Ultra fine, half tone 1 1 1
1: Send by cutting both edges without reduction 0: Send by reduction
1: Send as A3 width document (A4)
without rotating
0: Send as A4 width document (A4R)
with rotating
1: Send as A4 width document (B5R)
without rotating
0: Send as B4 width document (B5)
with rotating
1: Send as A4 width document (A5R)
without rotating
0: Send as A4 width document (A5)
with rotating
1: Access to EEPROM inhibited 0: Access to EEPROM allowed