Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-23
External
telephone
handset
External
telephone
connection
External telephone connection Initial setup SW 3-2 External telephone connection
Handset
connection
handset connection Initial setup SW 3-1 Handset connection
Handset
volume setup
Handset volume Initial setup SW 52-7~8 Handset volume adjustment
External
telephone off-
hook detection
External telephone off-hook detection time SW 12-1~8 External telephone off-hook detection
error
Remote switch
number
Remote switch number setup Initial setup SW 13-1~8 Remote switch detection error
Remote switch
setup
Remove reception command SW 14-1 Remote switch inhibit
External telephone notification in remote
switching
SW 14-2
Remote switch enable SW 14-3 Remote switch is made when calling
from external telephone.
TEL/FAX auto
switch
<Japan Only>
TEL/FAX auto switch setup Initial setup SW 7-1 The line is used either for TEL or
FAX.
Voice response send level to the line SW 51-1
Voice response send in TEL/FAX auto switch SW 51-2~3
Number of ring back tone preceding send SW 9-5~8
External
telephone call
Number of calls by external telephone
pseudo-ringing sound
Initial setup SW 9-1~4
Ring back tone ON time SW 10-1~4 External telephone call disable
CNG detection disable
Ring back tone OFF time SW 10-5~8 External telephone call disable
CNG detection disable
Communication General Signal send level SW 15-5~8 When the remote machine does not
receive signals in a proper level.
Polarity reversion monitor in communication SW 23-2 When the line is disconnected during
communication, the communication
report code 2 of 11 or 20 is resulted.
ECM (Other than V.34 mode) Initial setup SW 17-5 Error resend frequently occurs, resulting
in extended communication time.
Timer setup between flag-adrs (V.21-FSK) SW 20-3~4 Communication error in a satellite line
Send/receive coding capacity SW 17-7~8 Error in JBIG mode
SG3 V.34 mode function SW 43-1 Frequent errors in SG3 communication
V.34 Symbol Rate Mask SW 43-3~6 Frequent errors in SG3 communication
V.34 mode function in manual
communication
SW 42-8 Frequent errors in SG3 communication in
FAX service
Send G3/SG3 Countermeasures against echo in sending SW 20-7 An error occurs in phase B.
DIS reception confirmation SW 20-2 An error occurs in phase B.
CED detection time SW 25-5 CED signal detection error
SG3 V.34 mode send speed SW 44-1~4 An error occurs in SG3 communication.
G3 Echo suppresser tone SW 27-1~4 An error occurs in V.29 communication
Modem send speed SW 16-1~4 To uncertain/certain receiver
DCS-TCF interval time SW 24-1 An error occurs in training.
Error process in RTN reception SW 30-2 OK is displayed when RTN is received.
Receive G3/SG3 CSI send SW 20-1
Max. reception length SW 7-4 When receiving document of 1.5m or
longer
SG3 V.34 mode reception speed SW 44-5~8 An error occurs in SG3 communication.
G3 Countermeasures against echo in reception SW 20-6 An error occurs n phase B in reception.
Modem speed fixed in reception SW 16-5~6 Fall back or an error occurs due to poor
line conditions.
EOL detection timer SW 23-1 EOL time up occurs frequently.
RTN send line error rate SW 23-7~8 Line error occurs frequently.
EQM judgment in TCF reception
confirmation
SW 24-2 TCF reception error occurs.
TCF reception confirmation judgment
method
SW 24-3 TCF reception error occurs.
Large item Medium item Content of switch Key operator Soft SW No. Purpose of use