Specifications

AR-FX5 SIMULATIONS, FAX SOFTWARE SWITCH 6-10
<Country codes>
* Conforms to Advisory Document T.35.
<List of display values>
<Items>
66-2
Purpose Data clear
Function (Content) Used to set the FAX soft switch setup to the
default. (Except for the adjustment values)
Section FAX
Item Data
Operation/Procedure The current set value of SW1 is displayed.
Entry of 1 - 8 only is effective.
1) Specify the bit to be changed (highlighted)
with a number.
2) Select the country code, and press START to
rewrite the setting.
3) Select a number (1 - 2) with 10 digit key pad
and press START to execute.
1: FAX soft SW clear 2: Not clear
4) The soft switch (excluding the FAX adjustment
value) corresponding to the selected country
code is cleared.
5) The selected country is highlighted.
Japan 00000000
U.S.A. 10110101
1
JAPAN
SIMULATION 66-2
FAX SOFT SW. CLEAR.
ARE YOU SURE?
1:YES
2:NO
00000000
SIMULATION 66-2
FAX SOFT SW.CLEAR (WIHTOUT ADJUSTMENT VALUE).
INPUT COUNTRY CODE, AND PRESS START.
1 2 3 4 5 6 7 8
Press [START] key.
66-3
Purpose Operation test, check
Function (Content) Used to check the operations of FAX PWB
memory (read/write).
(This adjustment is required when replacing the
PWB with a new one.)
Section FAX
Item Data
Operation/Procedure Check the FAX PWB memory.
When this simulation is executed, the error
occurring address or the data line is displayed.
NO CHECK Not checked
CHECKING Checking
OK Check complete OK
NG Check error
MFP SRAM (MFP control PWB) SRAM
MFP FLASH (FAX I/F PWB) FLASH Memory
MFP OP.FLASH (FAX I/F PWB) FLASH Memory (AR-MM9)
MODEM EEPROM (FAX PWB)
MODEM SRAM(G/A) (FAX PWB)
MODEM SRAM (FAX PWB)
MODEM SDRAM (FAX PWB)
SIMULATION 66-3
FAX PWB MEMORY CHECK.
MFP SRAM: CHECKING
MFP FLASH: NO CHECK
MFP OP. FLASH: NO CHECK
MODEM EEPROM: NG:A0010000
MODEM SRAM(G/A):NO CHECK
MODEM SRAM: NG A11
MODEM SDRAM: OK