User Manual

POLLING
83
Polling
3
4
Enter the fax number of the other machine with the numeric keys, and
then press the OK key.
●
You can also use a rapid dialing, Speed Dial number, the Address List, or the REDIAL
key to enter the number.
●
If you press a group key, you will change to serial polling. In this case, proceed from step
4 of the serial polling procedure below.
●
If you make a mistake, press the CLEAR key and then enter the correct number before
you press the START key.
5
Press the START key.
●
Your machine automatically dials the other machine and begins polling.
Notes
●
To cancel a polling job, press the JOB STATUS key and then cancel the job in the job status
screen. (See page 37)
●
You can check the stored job in the job status screen. (See page 115)
Serial polling
1
In Fax mode, press the SPECIAL FUNCTION key.
2
Press the or key to select "SENDING OPTIONS" and then press
the OK key.
3
Press the or key to select "SERIAL POLLING" and then press the
OK key.
4
Enter the fax number of the other machine with the numeric keys, and
then press the OK key.
●
You can also use a rapid dialing, Speed Dial number, or group key.
●
If you wish to use the REDIAL key, use it before entering any other numbers.
●
After entering a fax number, press the OK key. Repeat step 4 to enter other fax numbers
(up to 200).
●
If you enter an incorrect number, press the CLEAR and then enter the correct number.
5
When you have entered all of the fax numbers, press the START key.
6
Press the START key.
●
Your machine automatically dials the other machines and begins serial polling.
Notes
●
You cannot enter the same number twice in step 4.
●
If you use two group keys that have 50 stations each, the total number of destinations entered
will be 100.
●
To cancel a polling job, press the JOB STATUS key and then cancel the job in the job status
screen. (See page 37)
DQQMࡍ࡯ࠫ㧞㧜㧜㧝ᐕ㧣᦬㧝㧣ᣣޓἫᦐᣣޓඦᓟ㧢ᤨ㧡㧢ಽ