User Manual

28
Sending a Fax
SENDING A FAX
This procedure is for sending a fax by memory transmission (See page 31) when the receiving machine
is in auto reception mode.
Sending a Fax Using the SPF
Use this method to scan and send one or more sheet originals (up to the sheet number limit).
●
You can preset the original size, resolution, and exposure. (See pages 23, 24)
1
Insert the originals into the document feeder tray. (See page 21)
●
Insert the originals face up.
●
Check and adjust the original size, resolution, and exposure settings as necessary.
2
Enter the fax number with the numeric keys.
●
Up to 40 digits can be entered. (Up to 50 digits can be entered when using Chain dialing.)
●
If you make a mistake, press the CLEAR key to clear the incorrect digit and then enter
the correct digit.
3
Press the START key.
●
After the first page is scanned, your machine dials the other machine and begins
transmission while the remaining pages are scanned.
●
The original is output to the original output tray.
Notes
●
If you wish to have all pages scanned into memory before transmission is begun, use the key
operator program to turn off the Quick On-line setting. (See page 154)
●
To cancel transmission, press the CLEAR key or cancel the job in the transmission job screen.
(See page 39)
●
If the power is turned off or a power failure occurs while an original is being scanned, the
machine will stop and a misfeed will occur. After the power is restored, remove the original as
explained in "Misfeed Removal" in the copy manual.
฀
฀
฀
฀
฀

฀
฀
DQQMࡍ࡯ࠫ㧞㧜㧜㧝ᐕ㧣᦬㧝㧣ᣣޓἫᦐᣣޓඦᓟ㧢ᤨ㧡㧢ಽ