User Manual

19
About the original
1
ABOUT THE ORIGINAL
Originals that can be Faxed
Original sizes
In addition to the standard sizes (11" x 17", 8-1/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2", A4,
and A4R), originals within the following size range can also be faxed.
*Long originals
Depending on the resolution setting and the width of the original, there may not be sufficient space in
memory to hold a long original. In this case, refer to the following table and select a lower resolution
setting and/or shorten the original.
(unit : inch)
Scanning area of originals
When faxing an original, note that the edges of the original cannot be scanned.
Automatic reduction of faxed originals
If you send a original of a larger width than the paper in the receiving fax machine, the original will be
automatically reduced.
●
You can turn off automatic reduction. In this case, the sides of the original will not be transmitted. (See
page 153)
Minimum original size Maximum original size
Using the SPF 5-1/2" x 8-1/2" 11" (width) x 39.3" (length)*
*Long originals can be loaded.
Using the platen glass 11" x 17"
11" wide 8-1/2" wide
Standard 39.3" 39.3"
Fine 39.3" 39.3"
Super fine 39.3" 39.3"
Ultra fine 34.6" 39.3"
Area that cannot
be scanned
: Leading edge: (0.2") 5 mm or less
: Trailing edge: (0.2") 5 mm or less
: Near side and far side: (0.24") 6 mm
or less
Width of original Paper size in receiving
machine
Size after reduction Ratio
11" x 17" 8-1/2” x 11” 8-1/2” x 11”R 1 : 0.50 (Area ratio)
Area that cannot be scanned
Trailing
edge
Leading
edge
Far side
Near side
HOࡍ࡯ࠫ㧞㧜㧜㧝ᐕ㧣᦬㧝㧥ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧞ಽ