User Manual

KEY OPERATOR PROGRAM LIST
141
Key Operator Program List
Setting Program name Program function (description) Page
SENDING
FUNCTION
PAGE COUNTER
SET
This setting is used to select whether page numbers are printed
at the top of transmitted fax pages.
153
SEND MODE This setting is used to select whether the standard mode for
sending faxes is memory transmission or direct transmission.
154
QUICK ON LINE TX When the send mode is set to memory transmission, this setting
determines whether normal memory transmission or Quick On
Line transmission is performed.
154
PRINT STATION #
IN RCVD DATA
This setting is used to select the position of the date and sender
information that is printed at the top of transmitted fax pages.
154
ACC. NAME PRINT When using ACC mode, this setting determines whether or not
the recipient is notified of the sender's ACC name when a fax is
sent.
155
RECALL SETTING
(BUSY)
When you attempt to send a fax and the line of the receiving
machine is busy, your machine will automatically re-attempt the
call. This setting is used to select the number of recall attempts
that will be made and the interval between attempts.
155
RECALL SET(ERR) This setting is used to select the number of recall attempts that
will be made and the interval between attempts when a
transmission is not successful due to a line error.
156
# OF RINGS AUTO
TX
This setting is used to set the time limit for the other machine to
respond when your machine attempts to send a fax by
automatic dialing. If there is no response within the time limit,
your machine automatically breaks the connection.
156
AUTO COVER
SHEET
This setting is used to have a cover sheet automatically
included with each fax transmission.
157
RCV. FUNCTION #OF RINGS AT. RX This setting is used to select the number of rings the machine
waits before answering in automatic reception mode.
157
TRAY SELECTION This setting is used to select which output trays can be used for
received faxes.
158
RECEIVED DATA
PRINT CONDITION
This setting is used to select how a received fax should be
printed when the machine does not have the same size of paper
as the received image. The fax can be either reduced or divided
before printing.
158
AUTO RCV
REDUCE TO
REGULAR SIZE
This setting is used to select automatic reduction to the set
paper size of the paper tray when you receive a non-standard
size fax that is larger than your paper.
159
A3 RX REDUCE This setting is used to select automatic reduction of received A3
faxes before printing.
159
FW. RX DATA When your machine receives a fax to memory because it is
unable to print, this setting is used to select automatic
forwarding of the fax to a destination stored using this program.
159
RECEIVED DATA
FW. STATION SET
This setting is used to store the destination fax number for
forwarding faxes received to memory.
160
INDEX PRINT This setting is used to have a black mark (index) printed at the
top of each received fax.
160
EARLIER OUTPUT When a received fax cannot be printed because the machine is
out of appropriate paper and a fax is subsequently received that
can be printed, this setting determines whether the subsequent
fax is printed before the fax that cannot be printed.
161
ANTI JUNK FAX This setting is used to block reception of faxes from specified
fax numbers.
161
ENTER JUNK FAX # This setting is used to program numbers from which you wish to
block fax reception.
161
DQQMࡍ࡯ࠫ㧞㧜㧜㧝ᐕ㧣᦬㧝㧣ᣣޓἫᦐᣣޓඦᓟ㧢ᤨ㧡㧢ಽ