User Manual

PRINTING LISTS
122
Printing Lists
Reception Result Explanation
OK Reception was completed successfully.
P. FAIL The power was turned off or a power failure occurred.
MEM. FULL The image memory became full during substitute reception to memory.
LENGTH OVER Received a fax that was longer than the standard size.
SUB RX REF. Printing is not possible and substitute reception to memory is prohibited.
CONF. ERROR When confidential reception was attempted,
(1) The specified confidential box number was not programmed in your
machine.
(2) The sending machine did not specify a confidential box number.
CONF RX CNCL When confidential reception was attempted,
(1) The sending machine did not have its fax number programmed.
NO RX POLL When polling was attempted,
(1) Your fax number was not programmed in your machine.
(2) Your fax number was not programmed as a polling passcode number in
the other machine.
(3) Your system number did not match one of the other machine's ID
numbers.
(4) Your system number did not match the other machine's system number.
RX NO POLL When polling was attempted,
(1) The other machine did not have a polling function.
(2) The other machine did not have a document stored for memory polling.
REL REQ FAIL When you received a relay request transmission,
(1) The sending machine did not have its fax number programmed.
(2) The sending machine specified an auto dial number for an end receiving
machine that is not stored in your machine.
REL RQ FAIL When you received a relay request transmission,
(1) The sending machine's fax number was not stored as a relay ID number
in your machine.
ERRORxx xxxx Line conditions prevented the reception from taking place normally.
First 2 digits of line error code: Error code from 00 to 31
Last 4 digits of line error code: Code for use by service technicians.
xxx-xxx OK When serial polling ended normally,
xxx- : Indicates total number of transmissions.
xxx OK : Indicates completed transmissions.
NO SA POLLING When F-code memory polling was attempted,
(1) The other machine did not have a F-code function.
(2) The other machine did not have an F-code programmed.
(3) The other machine did not have a document stored in the F-code memory
polling box.
SA POL TX ERR When F-code polling was attempted,
(1) The sub-addresses did not match.
(2) The passcodes did not match.
(3) The other machine's F-code memory boxes were for F-code relay
request transmission or for F-code confidential transmission.
S ADD RX FAIL When F-code reception was attempted,
(1) The sub-addresses did not match or were not programmed.
(2) The passcodes did not match or were not programmed.
(3) An F-code memory box was programmed.
JUNK FAX ERR The Anti Junk Fax function broke the connection and generated a line error.
DQQMࡍ࡯ࠫ㧞㧜㧜㧝ᐕ㧣᦬㧝㧣ᣣޓἫᦐᣣޓඦᓟ㧢ᤨ㧡㧢ಽ