User Manual

PROGRAMS
97
Programs
3
8
Press the or key to select the desired transmission method and
then press the OK key.
●
To cancel a selection, select it again and press the key.
9
Select settings for the transmission method.
●
A checkmark ( ) appears beside the selected method.
10
Select settings as needed.
●
A checkmark ( ) appears beside the selected method.
●
If you do not need to select any of the following settings, go to step 11.
11
When the settings are completed, press the START key. If you wish to
store another program, go back to step 5.
12
If you are finished storing programs, press the CLEAR ALL key.
Notes
●
Transmission or reception is possible after a program is stored.
●
You can check the contents of a program (transmission type, destination) by printing the
Program list. (See page 125)
●
Some combinations of settings selected in steps 9 and 10 may not be possible. In this case, a
message will appear.
Clearing a program
Before clearing a program, print the Program list to check the contents. (See page 125)
A program cannot be edited after it is stored. To change a program, clear it and then store it again.
Transmission method Page
Normal transmission 28
Broadcast transmission 70
Confidential transmission 74
Relay request transmission 77
Polling 81
Serial polling 81
F-code transmission 87
F-code polling 91
Setting Page
Store original (memory polling
and F-code memory polling)
84, 93
Cover sheet / message 108, 109
Resolution and exposure 24
Page division 107
Duplex scanning 106
Transmission settings 32
DQQMࡍ࡯ࠫ㧞㧜㧜㧝ᐕ㧣᦬㧝㧣ᣣޓἫᦐᣣޓඦᓟ㧢ᤨ㧡㧢ಽ