Specifications

AR-FX12 MACHINE OPERATION 7-9
(3) Communication report sub code
Report code 2 Content of communication interruption Send/Receive
01 Send length over Send
02 EOL time up Receive
03 Carrier detection time up Receive
04 Not used -
05 Time up in phase C (8 min) Send
06 Memory image decode error Receive
07 Memory image decode error Send
08 Time up between frames in phase C (Report code is 0 or 16.) Send/Receive
09 Not used -
10 Not used -
11 Polarity reversion detection Receive
12 Invalid command reception Receive
13 Time up (1-minute timer/6-second time) Receive
14 PUT error Receive
15 In V.34 mode, time up is generated when shifting from Primary to Control. Receive
16 In V.34 mode, time up is generated when shifting from Control to Primary. Receive
17 Command receive time-up from MFP controller Receive
18 Not used -
19 Not used -
20 Polarity reversion detection Send
21 Invalid command reception Send
22 Fallback retry number over Send
23 Command retry number resend over Send
24 Time up (T5 timer) Send
25 Time up (T5 timer) in V.34 mode Send
26 In V.34 mode, time up is generated when shifting from Primary to Control. Send
27 In V.34 mode, time up is generated when shifting from Control to Primary. Send
28 Modem chip response NG *1 Send/Receive
29 Not used -
30 A communication error is generated between MFP controller and Modem controller. (Report code is 0 or 16.)
31 DC current not detected (busy) Send
32 Dial tone not detected (busy) Send
33 Busy tone detection (busy) Send
34 T0 time up (Remote machine not responding) Send
35 T1 time up (Remote machine not responding) Send
36 In dialing, polarity reversion detection (Remote machine not responding) Send
37 Calling is not made (busy)<Collision detected (including CNG detection)> Send
38 JBIG chip response NG Send/Receive
60 In resend of document filed data, an error occurs in decoding or coding.
61 In resend of document filed data, setting to inhibit resolution conversion is made.
(The resolution after resend is set to be Enlarged.)
62 In resend of document filed data, rotation setting is made for data which cannot be rotated.
63 In resend of document filed data, data cannot be stored in HD after conversion of resolution for resend.
70 E-mail header acquisition error
71 Time out occurs during e-mail receive.
72 Receive reject occurs during e-mail receive.
73 Because of port disable, network communication is failed. Network send
74 Authentication by the POP server is failed when POP before SMTP setting is valid. Network send
80 There is no attached file in received e-mail.
81 The attached file of received e-mail is not of TIFF type which is supported.
82 The TIFF type of the attached file in received e-mail cannot be recognized. ID error
83 The TIFF type of the attached file in received e-mail cannot be recognized. Endian error
84 The TIFF type of the attached file in received e-mail cannot be recognized. Version error
85 The TIFF type of the attached file in received e-mail cannot be recognized. Tag data error
86 The TIFF type of the attached file in received e-mail cannot be recognized. Tag parameter error
87 The TIFF type of the attached file in received e-mail cannot be recognized. Header size error
88 The TIFF type of the attached file in received e-mail cannot be recognized. Data error
[07]MACHINEOPERATION.fm 9 ページ ２００４年１０月２６日 火曜日 午後３時４５分