Specifications

AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-41
46 1 Primary channel return
mode setup
Used to set the next state after completion of primary channel phase. 1 PPh signal
2 Dial tone detection kind Used to set whether continuous or intermittent (repetition of ON/OFF) is
detected as detection of the dial tone (DT) from the line switchboard.
0 Continuous
only
3-6 Not used 0
0
0
0
7,8 V.8 mode ANSam signal
send time
Used to set ANSam signal send time when sending ANSam signal in V.8 mode. 0 4sec
1
47 1-8 Not used 1
0
0
1
0
0
1
1
48 1-3 Not used 0
1
0
4 Dial tone ON/OFF
detection time lower limit
(in continuous detection)
Used to set the lower limit of detection time of ON/OFF when SW46-2 is set to
"Continuous."
0 100ms
5 Dial tone ON/OFF
detection time upper
limit (in continuous
detection)
Used to set the upper limit of detection time of ON/OFF when SW46-2 is set to
"Intermittent."
0 700ms
6-8 Not used 0
1
0
49 1-8 Dial number in tone
pulse auto setting
Used to set dial number (2 digits) in auto setting of telephone kind (DP/DTMF).
Setting is made by BCD input.
The set range is 0 ~ B. When set to outside the set range, the default value of
55 is applied to.
055
1
0
1
0
1
0
1
50 1-4 After sending CFR, dual
waiting is inhibited for
1.6sec.
Used to set the time of inhibition of both waiting (low speed and high speed)
after sending the CFR signal from the machine in the reception procedure other
than V.34.
Other value than the above: Set value x 200ms.
0 1600ms
0
0
0
5-6 Not used 0
0
SW
No.
Bit
No.
Item Switch selection and function USA Initial value Key
operator
1: PPh signal send
sequence
0: Sh signal send
sequence
1: Intermittent only 0: Continuous only
Bit No. 7 8
3sec 0 0
4sec 0 1
5sec 1 0
6sec 1 1
1: 300ms 0: 100ms
1: 400ms 0: 700ms
Bit No. 1234
0ms 1111
1600 0 0 0 0
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 41 ページ ２００４年１０月２６日 火曜日 午後３時４４分