Specifications

AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-38
37 7 Page number print Used to set whether the page number is added at the date/sender information
print position or not. (Page number/Total page number in case of memory
transmission)
0 Added Send setup
8 Not used 0
38 1,2 Protocol monitor Used to set whether the protocol monitor (which is recognized by the FAX) for
one communication is printed or not.
When a new communication is made before printing the protocol monitor, the
old protocol data are deleted. (Overwriting)
0NO
0
3 Line monitor display Used to set whether the communication speed during communication and the
reception level during reception are displayed on the LCD or not.
0Not
displayed
4-8 Time print (o'clock) on
the communication
report table
Used to set the time print (o'clock) when time is printed on the communication
report table. The set range is 0 - 23 o'clock by binary input. If a value of 24 - 31
is inputted, it is set to 0 o'clock.
0 0 o'clock Initial setup
0
0
0
0
39 1 Communication report
table printing at the
specified time
Used to set whether the communication report table is outputted at the
specified time or not.
Though time specification print is enabled, if the specified time is in the
nighttime FAX mode, output is not made.
0 Not output Initial setup
2-7 Time print (min) on the
communication report
table
Used to set the time print (min) when time is printed on the communication
report table.
The set range is 0 - 59min by binary input. If a value of 60 - 63 is inputted, it is
set to 0 min.
0 0 min Initial setup
0
0
0
0
0
8 Automatic print of
communication report
table at memory full
Used to set whether the communication report table is automatically outputted
or not when the number of send/receive items reaches 50 items.
If the report is not outputted, the oldest data are overwritten.
0 Not output Initial setup
40 1 Print of total
communication time on
the communication
report table
Used to set whether the total communication time and the total number of
pages are printed on the communication report table or not.
0Print
2 Report output (when in
receive rejection)
<FAX only>
Used to set whether the communication report is outputted or not when FAX
receive is set to "receive reject." However, report output (in receive) must be set
to "Not print."
0 Not printed
3 Sent document print in F
code communication
Used to set whether part of the sent document is printed or not on the
communication report table in F code communication. The setup of SW41-1
and SW41-2 has priority over this setup.
0 Not printed.
4 Report output
(When canceling)
Used to set whether the communication report table is outputted or not when
transmission is canceled during transmission of document.
0 Not output
SW
No.
Bit
No.
Item Switch selection and function USA Initial value Key
operator
1: Not added 0: Added
Bit No. 1 2
NO (Not print) 0 0
NO (Not print) 0 1
Print (Always) 1 0
Only in an error (Print) 1 1
1: Displayed on LCD 0: Not displayed on LCD
1: Communication report
table is printed at the
specified time.
0: Communication report
table is not printed at
the specified time.
1: Automatic print 0: Not print
1: Not print 0: The total time and the total number of
pages are printed.
1: Printed 0: Not printed
1: Sent document is
printed.
0: Sent document is not
printed.
1: Communication report
table is printed.
0: Communication report
table is not printed.
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 38 ページ ２００４年１０月２６日 火曜日 午後３時４４分