Specifications

AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-35
26 4-8 Not used 0
0
0
0
0
27 1-4 Echo suppressor tone
setup
Used to set YES/NO of echo suppressor tone in each high-speed modulation
system.
0 YES
(No for V.29
only)
0
1
0
5-8 Not used 0
1
1
1
28 1-3 Not used 0
0
0
4-6 CNG signal detection
time (in TEL/FAX auto
selection)
Used to set the time for detection of the CNG signal of the remote machine
before calling an external telephone from connection of the line when the FAX
automatic selection is enable. When this item is set to a longer value, the mute
time on the calling side becomes longer.
Setting range: "Setting value + 2 sec"
When, however, it is set to 0, the time is 0 sec.
0 Receive
setup
0
0
7,8 Not used 0
0
29 1-5 FAX paper exit tray
setting
Used to specify the default output tray in the combination of each output
system. The combinations of the output trays are as follows.
In the case of the main unit only or the main unit without the manual feed tray
and with the duplex tray, the output is always made from the center tray.
0 Receive
setup
0
0
0
0
6-8 Not used 0
0
0
30 1 Not used 0
2 Error reception in RTN
reception
Used to set whether RTN signal reception is judged as an error or not. (Only in
G3 mode)
0 Judges as
an error
3-4 Not used 0
0
5-8 ID (No.) setting
(1st digit: When dial
inputting or dialing)
Used to set the ID No. when the PBX function is enabled. This setting is valid
when "ID" is set in SW59-7-8.If the set value is outside the specified range, the
default (0) is used.
0 0 Initial set up
0
0
0
SW
No.
Bit
No.
Item Switch selection and function USA Initial value Key
operator
Bit No.
V.33 1 1 : NO 0 : YES
V.17 2 1 : NO 0 : YES
V.29 3 1 : NO 0 : YES
V.27 4 1 : NO 0 : YES
Bit No.
Main unit + Manual Duplex 1 1:CENTER
TRAY
0:LEFT TRAY
Finisher + Duplex / Finisher 2 1:FINISHER
TOP TRAY
0:LEFT TRAY
Mail bin stacker + Duplex /
Mail bin stacker
31:MAIL BIN
TOP TRAY
0:LEFT TRAY
Main unit + Saddle finisher
+ Duplex
41:CENTER
TRAY
0:FINISHER
TRAY
Mail bin stacker + Saddle
finisher
51:MAIL BIN
TOP TRAY
0:FINISHER
TRAY
1: RTN reception is not
judged as an error.
0: RTN reception is
judged as an error.
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 35 ページ ２００４年１０月２６日 火曜日 午後３時４４分