Specifications

AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-26
TEL/FAX auto
switch
Voice answering send level to the line SW 51-1
External
telephone call
Ring back tone ON time SW 10-1~4 External telephone call disable
CNG detection disable
Ring back tone OFF time SW 10-5~8 External telephone call disable
CNG detection disable
Communication General Signal send level SW 15-1~8 When the remote machine does not
receive signals in a proper level.
ECM (Valid for other than V.34)
(Reflected on V.21 DIS/DCS.)
Initial setup SW 17-5 Error resend frequently occurs, resulting
in extended communication time.
Timer setup between flag and address
(V.21-FSK)
SW 20-3~4 Communication error in a satellite line
Coding capacity in send/receive
(V.34 communication)
(Reflected on DIS/DCS/DTC.)
SW 17-3~4 Error in JBIG mode
Coding capacity in send/receive
(Reflected on DIS/DCS/DTC)
(Other than V.34)
SW 17-7~8 Error in JBIG mode
SG3 V.34 mode function(When call out and
polling)
SW 43-1 Frequent errors in SG3 communication
V.34Symbol Rate Mask (when receiving) SW 43-3~6 Frequent errors in SG3 communication
V.34 mode function in manual
communication
SW 42-8 Frequent errors in SG3 communication in
FAX service
Send G3/SG3 Countermeasures against echo in
transmission
(Used to set the hold time from DIS reception
to signal sending.)
SW 20-7 An error occurs in phase B.
DIS reception confirmation in G3
transmission
SW 20-2 An error occurs in phase B.
V.34 mode transmission speed SW 25-5 CED signal detection error
SG3 V.34 mode transmission speed SW 44-1~4 An error occurs in SG3 communication.
G3 Echo suppresser tone setup SW 27-1~4 An error occurs in V.29 communication
Modem transmission speed (Except for V.34)
(DCS)
SW 16-1~4 To uncertain/certain receiver
DCS-TCF interval time SW 24-1 An error occurs in training.
Error process in RTN reception SW 30-2 OK is displayed when RTN is received.
Receive G3/SG3 CSI send SW 20-1
SG3 V.34 mode reception speed SW 44-5~8 An error occurs in SG3 communication.
G3 Countermeasures against echo in reception
(
CED tone send interval )
SW 20-6 An error occurs n phase B in reception.
Reception modem speed fixed
(other than V.34) (DIS)
SW 16-5~6 Fall back or an error occurs due to poor
line conditions.
EOL detection timer SW 23-1 EOL time up occurs frequently.
RTN send line error rate SW 23-7~8 Line error occurs frequently.
EQM judgment threshold value
when confirming TCF reception
SW 24-2 TCF reception error occurs.
Judgment method in confirmation of TCF
reception
SW 24-3 TCF reception error occurs.
Receive print Paper
selection
Sub scan length judgment SW 35-2 Print is not made on the selected paper.
FAX paper exit tray setup <Dragon>
Receive setup SW 28-7~8 Print is not made on the selected paper.
Received data print condition setup
Receive setup SW 35-3~4 To make divided print instead of
reduction print.
Automatic reduction/dispose setup
Receive setup SW 35-7 To disable reduction print.
Setup of magnification ratio in automatic
reduction
SW 36-1~8 To disable reduction print on fixed size
paper.
Reduction/dispose setup when printing A3,
11X 17
SW 35-8 Print is not made on the selected paper
when A3-11x17 size document is
received.
Duplex reception print
Receive setup SW 34-8 To make duplex print of received
document
Rotation print SW 35-1 To disable rotation print
Received document output setup SW 35-5 To print after reception of each page
11 x 17 paper reception width setup SW 37-3 To print 11x17 document as B4 width
Reception size specification
(Indicates reception capacity.)
SW 37-1~2 To limit the reception size.
Large item Medium item Content of switch Key operator Soft SW No. Purpose of use
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 26 ページ ２００４年１０月２６日 火曜日 午後３時４４分