Specifications

AR-FX11 SIMULATIONS, FAX SOFTWARE SWITCH 6-11
66 4 Signal send mode
Used to send signals to the line and the machine speaker by setting the signal number. (Signal send is
continued until interruption is instructed by pressing RETURN key.) The signal send level is selected from
0db and the soft SW values. Since the level setting is not required for 01 and 31 - 35, the selection menu
does not appear. The signal send level is returned to the soft SW set value before execution of the mode
when completing the mode.
6 Print pass code print
Used to print the confidential ID table (confidential box number, confidential box name, confidential pass
code). Sharp mode confidential information is printed separately.
Main
code
Sub
code
Contents Remark
Sim66-4 SIGNAL OUT
Sim66-4 SIGNAL OUT
Sim66-4 SIGNAL OUT
Sim66-4 SIGNAL OUT
Sim66-4 SIGNAL OUT
SIGNAL SELECT
(1 - 35)
1:NO SIGNAL
2:33600bps(V34)
3:31200bps(V34)
(1 - 35) XX
After selection with 10-key
OK
33600bps(V34)
1:MAX
2:SOFT SW.
(1 - 2) X
33600bps(V34)
0dB
EXEC
33600bps(V34)
PRESS BACK TO STOP
EXEC
Sim66-4 SIGNAL OUT
34:DP MAKE
35:DP BREAK
(1 - 35) XX
OK
After pressing OK key
OK
SIM66-4 initial window
CA key : Simulation cancel
Interrupt key : Sub code input window
C key : Input clear
key : Page select
10-key : Number input and item selection
OK key : Input value settlement and execution
START key : Input value settlement
RETURN key : Signal send stop
The window is switched with the up and down keys.
Input and switching the window are irrelevant.
Not highlighted with an input of a value.
The window is not switched, either.
When "1: NO SIGNAL" or "31: PSEUDO RNG" - "33: R.B. TONE NONE"
is selected, "0dB" and "SOFT SW" are not selected.
When one of these is selected, the second line is the signal name,
the third and fourth lines are empty, and the fifth line is EXEC display.
1sec later
Return
Sim66-6 PASS CODE
Sim66-6 PASS CODE
Sim66-6 PASS CODE
PRINT STORED
OK
PRINT CONF.
EXEC
NO DATA
Sim66-6 PASS CODE
CAN NOT PRINT
OK
OK
1sec later
1sec later
1sec later
CA key : Simulation cancel
Interrupt key : Sub code input
window
OK key : Settlement
START key : Settlement
C key : Disable
Return key : Disable
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 11 ページ ２００４年１１月１２日 金曜日 午後２時２４分