Specifications

AR-FX11 SIMULATIONS, FAX SOFTWARE SWITCH 6-1
[6] SIMULATIONS, FAX SOFTWARE SWITCH
1. Entering the simulation mode
Perform the following procedure to enter the simulation mode.
[#] [*] [C] [*] [Main code] [START] [Sub code]
[START]
2. Canceling the simulation mode
When the clear all key is pressed, the simulation mode is cancelled.
When the interruption key is pressed, the process is interrupted and the
screen returns to the sub code entering display.
* After canceling the simulation mode, be sure to turn OFF/ON the
power and check the operation.
Note:
• If the machine is terminated by a jam error or paper empty during
copying in the adjustment by the simulation, recopying is required.
• The values in the simulation columns are not default values but sample
values.
3. Simulation list
CODE FUNCTION(Contents)
MAIN SUB
22 11 FAX-related counter display
24 10 FAX-related counter clear
46 12 Density adjustment in the FAX mode
(Collective adjustments)
13-16 Density adjustment in the FAX mode
(Individual adjustments)
39 FAX sharpness adjustment
48 8 FAX magnification ratio adjustment
(scan)
9 FAX magnification ratio adjustment
(print)
50 8 FAX lead edge adjustment (scan)
9 FAX lead edge adjustment (print)
66 1 FAX soft SW setting
2 FAX soft SW initializing
3 FAX PWB memory check
4 Signal send mode
6 Print pass code print
7 Image memory content print
10 Image memory contents clear
11 300bps signal send
13 Dial test
17 DTMF signal send
19 SRAM backup
21 FAX information print
24 FAST SRAM clear
30 TEL/LIU status change check
31 TEL/LIU setting
32 Receive data check
33 Signal detection check
34 Communication time measurement
37 Speaker sound volume adjustment
38 Time setting/check
41 CI signal check
52 Pseudo ringer check
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 1 ページ ２００４年１１月１２日 金曜日 午後２時２４分