Specifications

AR-F14/PN1 UNPACKING AND INSTALLATION 3-1

[3] UNPACKING AND INSTALLATION

1.AR-F14

•For installation of AR-F14, an optional stand (small stand or large stand)

must have been installed.

•When adjusting the height of the finisher, be sure to perform step15)

with the finisher placed on the packing box.

•For improvement of workabillity, part of the description in this manual

may be modified without prior notice. In this case, refer to the service

manual.

Turn off the main switch of the copier and then remove the power plug

from the outlet.

1) Remove the exit tray cover.

•If the copier is equipped with an exit tray cover:

Remove the screw and then remove the exit tray cover as shown in the

illustration.

2) Remove the internal cabinet and the paper holder arm from the

copier.

<1>Pull the lock lever to the left and pull out the rail dummy cover to

the front.

(If the second exit tray is provided, remove it together with the rail

dummy cover.)

<2>Unlatch the pawls of the exit dummy cover and remove the exit

dummy cover.

<3>Remove the paper holder arm from the exit dummy cover.

<4>Remove the screw and then remove the rear exit cover.

3) Remove the rear cabinet.

<1>Remove the screw and then remove the maintenance cover.

<2>Remove the four screws and then remove the rear cabinet.

Punch position label:

2 sheets

Stapling position label:

2 sheets

Saddle finisher

instruction manual:

1 copy

[03]UNPACKINGANDINSTALLATION.fm 1 ページ２００４年４月２７日　火曜日　午後７時４分