Specifications

AR-F14/PN1 UNPACKING AND INSTALLATION 3-7
2. AR-PN1
<Before installation>
For installation of AR-PN1A/PN1B/PN1C/PN1D, a saddle stitch finisher
(AR-F14) must have been installed.
1) Turn off the main switch of the main unit.
<1> Then remove the power plug of the main unit from the outlet.
<2> Remove the connector of the finisher.
2) Remove the front cabinet and the rear cabinet from the finisher.
<1> Open the front door of the finisher and remove the jam handling dial.
<2> Remove the two front cabinet securing screws, pull out the staple
unit until it stops, then remove the pawl of the front cabinet in the
direction indicated by the arrow and remove the front cabinet..
<3> Remove the three rear cabinet securing screws, remove the pawl in
the direction indicated by the arrow, and remove the rear cabinet.
At this time, remove the relay harness through the opening of the
rear cabinet.
Parts included
Screw
(M4 x 6 with rosette)
: 1 pc.
Harness A (purple): 1 pc.
Harness B (orange): 1 pc.
Dust box label:
1 sheet
Hole punch position label*:
2 sheets
* Will not be used.
Use the hole punch
position labels packed
in AR-F14
OFF
Jam handling dial
Staple unit
Screws
Front cabinet
Pawl
Screw
Relay harness
Opening for
relay harness
Screw
Rear
cabinet
Pawl
[03]UNPACKINGANDINSTALLATION.fm 7 ページ ２００４年４月２７日 火曜日 午後７時４分