Specifications

AR-F14/PN1 UNPACKING AND INSTALLATION 3-6
<2>If the gap between the copier and the finisher is not uniform at
the upper and lower parts, remove the caps from the front side
and the rear side of the finisher stand with a flat-blade
screwdriver or the like.
Then, remove the screws of the front and rear subcovers (one
screw for each) and then remove the subcovers.
<3>Loosen the four adjustment section securing screws located at
the positions shown in the illustration and then rotate the front
and rear height adjusting screws so that the gap becomes
uniform.
<4>If the gap becomes uniform, tighten the adjustment section
securing screws and reattach the caps and the subcovers.
21) Connect the connector of the finisher.
Connect the connector of the finisher to the connector of the docking
unit.
Connect the connector of the finisher to the connector of the copier
and then tighten the screws.
22) Set the staple cartridge in the stapler unit.
<1>Open the finisher front cover and pull out the stapler unit.
<2>Turn the roller rotating knob unit the triangle mark is aligned with
the index.
<3>Insert the staple cartridge securely into the staple section unit it
clicks.
Note:Check also that the right and left parts of the staple
cartridge do not float.
<4>Insert the staple section and close the finisher front cover.
23) Paste the stapling position label.
Paste the stapling position label to the document feeder.
Insert the power plug of the copier to the outlet and turn on the main
switch of the copier.
Gap
Gap
Staple position label
[03]UNPACKINGANDINSTALLATION.fm 6 ページ ２００４年４月２７日 火曜日 午後７時４分