Specifications
Table Of Contents
- Contents
- About the Documentation
- Introduction
- Chapter 1: Printing from Windows Computers
- Chapter 2: Printing from Mac OS Computers
- Chapter 3: Printing from UNIX Workstations
- Chapter 4: Downloading Files and Fonts
- Chapter 5: Printing Variable Data Documents
- Chapter 6: Using EFI Hot Folders
- Chapter 7: Tracking and Monitoring Jobs
- Chapter 8: Using Fiery E- mail Service
- Appendix A: Print Options
- Appendix B: Font List
- Appendix C: Troubleshooting
- Index
A
129 Print Options
Sharp AR-C360P EFI Printing Guide - 129
4. Enter a starting page number for each chapter in the Chapter
start field if your job consists of multiple chapters and is printed
duplex.
Defining Chapter start guarantees an even number of pages to be
printed in each chapter. It is recommended to use this field when
you print a duplex multi-chapter document. Separate the page
numbers by commas. For example, if the chapters in a 4-chapter
document start on pages 1, 2, 34, and 56, enter 1,2,34,56.
Note:Enter all chapter starting page numbers, separated by commas.
Your entry in the Chapter start field applies to the entire document
regardless of the Page Ranges you specify in the Define Mixed Media
area.
5. For each page range, enter the page numbers and specify the
options for that range.
You can choose your specifications from the following options:
Page Range—Enter a page number or the range of page numbers.
Use a hyphen to define a range of sequential pages. For example,
1-3 prints the first three pages on a particular media type. The
range -14 prints the first 14 pages; 5- prints Page 5 through the
end of the document. If all the pages in multiple ranges use the
same media type, you can combine ranges with a comma; for
example, 4-5, 9-10.
You can insert a blank page by entering ^. For example, entering
^6 into the Page Range option inserts a blank page before page 6.
Note: You cannot combine a single page with page ranges.
Media Type
—Select a type of media you want to use for the range.
Paper Source—Select a paper tray with a media you want to use
for the range. The media type must be assigned to a tray at the
Sharp AR-C360P control panel.
Note:Document Default represents the setting you make outside the
Mixed Media dialog box. For example, if you set Paper Source to Tray 1
under the Paper Source print option bar, Document Default for Paper
Source in the Mixed Media dialog box is equal to Tray 1.
2 sided printing
—Select Long Edge Binding or Short Edge Binding
if you want to print on both sides of the paper.