Unit installation

AR-C330 SELF DIAG MESSAGE AND TROUBLESHOOTING 10 - 19
F1 10 Case 2 Trouble
position/
cause
Staple unit mechanism
section trouble
Remedy (Check) Check the staple
unit mechanism section
operation. (SIM 3-1/2)
(Repair) Replace or repair
the staple unit. / Power
OFF-ON
(After work)
Case 3 Trouble
position/
cause
Finisher control PWB
trouble
Remedy (Check) (SIM3-1/2) Check
the finisher control PWB
operation. (SIM 3-1/2)
(Repair) Replace the
finisher control PWB. /
Power OFF-ON
(After work) Make various
adjustments related to the
finisher electric section.
(Install the EEPROM of the
defective finisher control
PWB to a new finisher
control PWB.)
Main
code
Sub
code
Title
Finisher bundle process trouble
(Finisher side detection)
F1 11 Phenomena Display Lamp
Message
Detail In the initial operation, the
return roller home position
sensor signal ON is not
recognized within the
specified time after starting
rotation of the return roller. /
In the initial operation, the
bundle exit belt home
position sensor OFF is not
recognized within the
specified time after starting
bundle exit operation. / In
the initial operation, the
bundle exit belt home
position sensor signal ON is
not recognized within the
specified time after starting
bundle exit operation.
Section Finisher paper exit
Operation
mode
Power ON / Initial operation
Note
Case 1 Trouble
position/
cause
Bundle process motor
trouble / Return roller home
position sensor trouble
Remedy (Check) Check operations
of the bundle process
motor/return roller home
position sensor. (SIM 3-1/2)
(Repair) Replace the
bundle process motor. /
Replace the return roller
home position sensor. /
Power OFF-ON
(After work)
Main
code
Sub
code
Title
Finisher staple trouble (Finisher
side detection)
F1 11 Case 2 Trouble
position/
cause
Return roller mechanism
section trouble
Remedy (Check) Return roller
mechanism section (SIM 3-
1/2)
(Repair) Repair the return
roller mechanism section. /
Power OFF-ON
(After work)
Case 3 Trouble
position/
cause
Finisher control PWB
trouble
Remedy (Check) Check the finisher
control PWB operation.
(SIM 3-1/2)
(Repair) Replace the
finisher control PWB. /
Power OFF-ON
(After work) Make various
adjustments related to the
finisher electric section.
(Install the EEPROM of the
defective finisher control
PWB to a new finisher
control PWB.)
Main
code
Sub
code
Title
Finisher tray lift trouble (Finisher
side detection)
F1 15 Phenomena Display Lamp
Message
Detail In the tray lift up operation,
the tray upper limit sensor
ON is recognized. / The
specified number or more of
the tray lift motor rotation
sensor signals are not
recognized within the
specified time after starting
rotation of the tray lift motor.
/ The tray paper height
sensor ON is not
recognized within the
specified time after starting
the tray lift up operation. /
The tray paper height
sensor OFF is not
recognized within the
specified time after starting
the tray lift down operation.
Section Finisher tray lift
Operation
mode
All modes
Note
Case 1 Trouble
position/
cause
Tray lift mechanism section
trouble
Remedy (Check) Check the tray lift
mechanism section. (SIM 3-
1/2)
(Repair) Repair the tray lift
mechanism section. /
Power OFF-ON
(After work)
Main
code
Sub
code
Title
Finisher bundle process trouble
(Finisher side detection)