Unit installation

AR-C330 SELF DIAG MESSAGE AND TROUBLESHOOTING 10 - 18
F1 0 Case 2 Trouble
position/
cause
Finisher control PWB error
Remedy (Check)
(Repair) Replace the
finisher control PWB./Power
OFF-ON
(After work) Make various
adjustments related to the
finisher electric section.
(Install the EEPROM of the
defective finisher control
PWB to a new finisher
control PWB.)
Case 3 Trouble
position/
cause
PCU MAIN PWB trouble
Remedy (Check)
(Repair) Replace the PCU
MAIN PWB. / Power OFF-
ON
(After work) Reenter the set
values and the adjustment
values. (Install the
EEPROM on the defective
PCU MAIN PWB to a new
PCU MAIN PWB.)
Main
code
Sub
code
Title
Finisher paper exit/reversing motor
trouble (Finisher side detection)
F1 2 Phenomena Display Lamp
Message
Detail In the initial operation, the
motor rotation sensor
output signal is not
recognized within the
specified time after output
of the finisher paper exit
motor / reversing motor ON
signal.
Section Finisher paper exit
Operation
mode
Power ON/ Initial operation
Note
Case 1 Trouble
position/
cause
Paper exit motor trouble /
Reversing motor trouble /
Paper exit motor rotation
sensor trouble / Reversing
motor rotation sensor
trouble
Remedy (Check) Check the paper
exit motor / reversing motor
/ Reversing motor rotation
sensor / paper exit motor
rotation sensor operations.
(SIM 3-1/2)
(Repair) Replace the paper
exit motor. / Replace the
paper exit motor rotation
sensor. / Power OFF-ON
(After work)
Main
code
Sub
code
Title
Communication trouble between
PCU MAIN PWB - Finisher control
PWB (Detected by PCU MAIN PWB)
F1 2 Case 2 Trouble
position/
cause
Paper exit mechanism
section trouble
Remedy (Check) Check the paper
exit mechanism section
operation. (SIM 3-1/2)
(Repair) Replace or repair
parts of the paper exit
mechanism section. /
Power OFF-ON
(After work)
Case 3 Trouble
position/
cause
Finisher control PWB
trouble
Remedy (Check) Check the finisher
control PWB operation.
(SIM 3-1/2)
(Repair) Replace the
finisher control PWB. /
Power OFF-ON
(After work) Make various
adjustments related to the
finisher electric section.
(Install the EEPROM of the
defective finisher control
PWB to a new finisher
control PWB.)
Main
code
Sub
code
Title
Finisher staple trouble (Finisher
side detection)
F1 10 Phenomena Display Lamp
Message
Detail The staple home position
sensor signal OFF is not
recognized within the
specified time after output
of the staple motor ON
signal. / Though the staple
home position sensor OFF
signal is recognized after
output of the staple motor
ON signal, but the staple
home position sensor ON
signal is not recognized
within the specified time.
Section Finisher stapler
Operation
mode
Stapling
Note
Case 1 Trouble
position/
cause
Staple motor trouble /
Staple home position
sensor trouble
Remedy (Check) Check the
operation of the staple
motor/staple home position
sensor. (SIM 3-1/2)
(Repair) Replace the staple
motor. / Replace the staple
home position sensor. /
Power OFF-ON
(After work)
Main
code
Sub
code
Title
Finisher paper exit/reversing motor
trouble (Finisher side detection)