Service manual

4-20

CHAPTER 4 REPLACEMENT OF PARTS

P. Feeder unit/board-RSF/MPT hopping roller/frame assy separator/

cover front

(1) Open the top cover.

(2) Remove the plate shield, and unplug the connector. (See Section "F".)

(3) Free the claws of Stay L 1 and Stay R 2, and remove feeder unit 3 by sliding it to the right.

(4) Detach the motor cover. (See Section "L" .)

(5) Disassemble cover sensor 4 by freeing the claw.

(6) Unplug the connector, and disassemble Board-RSF 5.

(7) Remove MPT Assy. (See Section "O".)

(8) Detach lever 6 by turning it until its claw is freed. (Tool No. 3)

(9) Remove two screws (black) 7, and detach stay L 1. (Tool No. 1)

(10) Remove four screws (black) 8, free two claws B on the front side, and disassemble feed

Assy 9. (Tool No. 1)

(11) Detach two lock shafts 0 and two springs A, and disassemble guide Assy B by freeing the

four claws.

(12) Remove hopping roller shaft C.

(13) Free the two fulcrums, and remove frame assembly separator D and spring E.

Feeder Unit / Board-RSF/ MPT Hopping Roller / Frame Assy Separator / Cover Front

Claws B

Claw