Service manual

4-11

CHAPTER 4 REPLACEMENT OF PARTS

H. Top cover assembly

(1) Detach the left side cover. (See Section "A. Left side cover".)

(2) Detach the right side cover. (See Section "B. Right side cover".)

(3) Detach the rear cover. (See Section "D. Rear cover".)

(4) Remove the plate assembly shield (GDI), and then, the control PCB. (See Section "F. Control PCB".)

(5) After unplugging the connector, disconnect hooked RFID cable 1.

(6) Remove two E-shaped retaining rings 2 and two spring torsions 3, and detach top cover

Assy 1. (Tool No. 8)

Top Cover Assy