Service manual

4-6
CHAPTER 4 REPLACEMENT OF PARTS
D. Rear cover
(1) Open the face-up tray.
(2) Remove two screws (silver) 1. (Tool No. 1)
(3) Insert the flat-tipped screwdriver (Tool No. 3) into hole A, as illustrated in Figure (2), and
release two claws A.
(4) Now, release two claws B, and pull the upper part of rear cover 2 in the direction of arrow
A.
(5) Push the lower part of rear cover 2 in the direction of arrow B, as shown in Figure (3), and
detach rear cover 2 by freeing three claws C.
Rear Cover
2
1
2
1
A
A
B
Figure (3)
Figure (2)
Figure (1)
ClawC
ClawC
ClawA
ClawA
ClawB
ClawB
HoleA
HoleA