Service manual

3-18
CHAPTER 3 INSTALLATION
Peeling the protective tapes off the duplex unit
Install Duplex Unit
1) Insert the duplex unit into the lower part on the back of the printer as far as it will
go.
2) Ensure that the claw on either side of the duplex unit is securely accommodated
in the hole of the printer.
Protective tapes (2)
Holes
Claws
Two-sided print unit
(4) Installation of built-in type hard disk
This is a built-in type hard disk to be added to the printer. It is used to conduct confirmation print,
authentication print, to store print jobs, or to make buffer print, and also when the [ COLLATE
FAIL] is indicated in a section-by-section print. Fonts cannot be downloaded to it.
Note! When the printer has a built-in type hard disk installed, make certain to switch off the
printer after executing the shutdown menu. If the power is turned off outright, the hard
disk may be damaged and broken.
Type: AR-C265HD
Memo The hard disk is segmented into the three partitions of "PCL," "Common" and "PSE."
When the printer is shipped out of the factory or the hard disk is initialized, the following
sizes are assigned to the partitions: