Service manual

7-16
CHAPTER 7 TROUBLESHOOTING PROCEDURES
Service Call Error (6/7)
Service call
220:Error
Service call
230:Error
Service call
231:Error
Service call
250:Error
Service call
251:Error
Power off/on
901:Error
902:Error
Power off/on
903:Error
904:Error
Take off the HDD or replaced?
RFID read device error
Is the error issued again?
An interface error was detected
with the RFID reader device.
01: communication error
between the RFID reader and
the engine PCB.
02: the transceiver circuit error
of the RFID reader.
03: communication error
between the RFID reader and
the Tag chip.
04: the RFID Tag detection
error(more than 4 chips).
An erasing error of an encrypted
file was detected.
Did the user agree to execute
HDD ERASE?
An error was detected during
Disk ERASE.
Can the error indication be
reproduced?
Is belt thermistor cable setting
proper?
Does error reoccur?
Is belt thermistor cable setting
proper?
Does error reoccur?
Reset original HDD.
Check the connection of
the RFID R/W board.
Replace the RFID R/W
board.
Replace the S2V PCB.
01: Same as Error 230
02: Replace RFID R/W
board.
03: Check the antenna
cable connection.
04: Check to see if the
quantity of RFID Tags is
correct.
Notify the user that Disk
ERASE needs to be
executed to erase the
encrypted file, so that
the HDD is restored to
the original state as at
the time of purchase.
ADMIN MENU
HDD ERASE
Turn the power off and
on again.
Replace the HDD.
Connect cable set
pr
operly again.
Turn power ON again.
Replace belt
thermistor.
Connect cable set
properly again.
Turn power ON again.
Replace belt thermistor
and leave aside for 30
min. Then turn power ON
again.
False setting of a
record medium
detected by a print
statistics.
RFID Reader not
Installed
RFID Reader I/F
Error
Secure File
Erasing Error
Secure Disk
Erasing Error
Short or open in
belt thermistor
detected.
Abnormal tempera-
ture detected by
belt thermistor
(high-temp or low
temp.)
Yes
Yes
Yes
Yes
No
Yes
Yes
No
Yes
Yes
Error DescriptionMessage Cause Solution