Service manual

5-31
CHAPTER 5 MAINTENANCE MENUS
Description Level
Ready
LED
Attention
LED
LCD (English)
(■
■
means no display in upper line)
PRINT NETWORK CONFIG
■
■
COLLATE COPY iii/jjj
■
■
COPY kkk/lll
VERIFYING JOB
CANCELING JOB
CANCELING JOB
(JAM)
CANCELING JOB
(USER DENIED)
CANCELING JOB
(BUFFER FULL)
■
■
ADJUSTING TEMP
■
■
OPTIMIZING TEMP
■
■
POWER SAVE
■
■
ADJUSTING COLOR
Varies
Varies
Varies
Blink
Blink
Blink
Blink
Blink
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Varies
It is shown that a network setup is printing.
If "Print Summary", "Print Information" of each slot are
chosen by menu "Print Information"-"Network", printing
of a network setup will be started.
Collate printing. iii: The number of copy in printing. jjj: the
total number of printing. When the total number of
printing is 1, it is a normal printing display.
In status of Priority=121 ~ 125, Display Priority is 39.
Copy printing. kkk: The number of pages in printing. lll:
The total number of printing. When the number of copy
is 1, it is a normal printing display.
In status of Priority=121 ~ 125, Display Priority is 39.
Indicates that the integrity of print data for encrypted
authentication is being verified (for corruption and
tampering).
Indicates that job cancellation has been instructed and
data is being ignored until the job completion.
Indicates if JAM occurs when Jam Recover is OFF, that
job cancellation has been instructed and data is being
ignored until the job completion.
Indicates a job being cancelled due to no print permit.
(Related to JobAccount)
1. A job received from a user who is denied printing.
2. A color job received from a user who is denied color
printing.
Indicates that a job is being cancelled because the
printer area where the logs are stored has been used up
and also "Cancel job" is specified as an operation at the
time of Log Full. (Related to JobAccount)
Warming up.
In this case, Leisus I/F : STSENG bit #0 should be '0'.
Indicates that printing has been suspended for a while
due to high temperature of the drum, or the printer is in a
wait state to cope with heat at the time of switching
narrow paper to wide paper.
A printer is in power save mode. Displayed in a
combination of other message in the first line.
LCD back light extincts in the energy saving mode and
blinks after that mode. If the power is on during the
energy saving mode, it lights up and extincts after 30
seconds. However, the energy saming mode remains.
Also, it lights up in the priority 365 in shut down process.
Executing Auto Color Adjusting
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal