Service manual

AR-C200P Rev.5 100 /
3.2.5 Recovery Flash ROM data on TIG board
A 4MB Flash ROM that enables a user to register an arbitrary file is installed on the TIG board.
When a TIG board has to be replaced, print a file list of the information menu and check the
registered files before replacing the board.
Re-register necessary files when the TIG board is replaced.
3.3 Adjusting the Density
The auto density adjust mode is set to [Auto] when the printer is delivered, however, problems may
occur upon using the printer if the mode is set to [Manual]. Perform the procedure when the density
is improper.
Note: Perform the task when the printer is not in operation. Do not perform during warm-up.
(1) Press
))
))
) several times and display [Color Menu].
(2) Press
11
11
1 or
55
55
5 and display [Density Adjust/Start].
(3) Press
33
33
3.
The auto density adjustment will begin.