Troubleshooting guide
Table Of Contents
- CONTENTS
- INTRODUCTION
- BEFORE USING THE MACHINE
- COPY FUNCTIONS
- PRINTER FUNCTIONS
- BASIC PRINTING
- PRINTER DRIVER SETTING SCREEN
- SETTING ADVANCED PRINT FUNCTIONS
- PRINTING MULTIPLE PAGES ON ONE PAGE (N-Up Printing)
- FITTING THE PRINTED IMAGE TO THE PAPER (Fit To Paper Size)
- ROTATING THE PRINT IMAGE 180 DEGREES (Rotate 180 degrees)
- ENLARGING/REDUCING THE PRINT IMAGE (Zoom)
- PRINTING FAINT TEXT AND LINES IN BLACK (Text To Black/Vector To Black)
- ADJUSTING THE BRIGHTNESS AND CONTRAST OF THE IMAGE (Image Adjustment)
- ADDING A WATERMARK TO PRINTED PAGES (Watermark)
- TWO-SIDED PRINTING (AR-5516D/AR-5520D)
- SAVING FREQUENTLY USED PRINT SETTINGS
- OUTLINE OF THE PRINT STATUS WINDOW
- SCANNER FUNCTIONS
- USER SETTINGS
- TROUBLESHOOTING
- ROUTINE MAINTENANCE
- PERIPHERAL DEVICES AND SUPPLIES
66
TROUBLESHOOTING
Paper misfeed.
Misfeed occurs.
→ To remove the misfeed, see "MISFEED REMOVAL".
73
The paper is outside of the specified size and weight
range.
→ Use copy paper within the specified range.
9
Paper curled or damp.
→ Do not use curled or crimped paper. Replace with dry copy paper.
During periods when the machine is not used for a long time,
remove the paper from the tray and store it in a dark place in a
bag to prevent moisture absorption.
–
Paper is not loaded properly.
→ Make sure the paper is properly installed.
10
Pieces of paper inside machine.
→ Remove all pieces of misfed paper.
73
Too much paper is loaded in the tray.
→ If the stack of paper is higher than the indicator line on the tray,
remove some of the paper and reload so that the stack does not
exceed the line.
10
The guides on the bypass tray do not match the width of
the paper.
→ Adjust the guides to match the width of the paper.
11
The bypass tray extension is not pulled out.
→ When loading a large size of paper, pull out the extension.
11
The bypass paper feed roller is dirty.
→ Clean the roller.
84
A5 paper is loaded in lower paper tray or in the 250-sheet
or 2 x 250-sheet paper feed unit.
→ A5 size paper must be loaded in upper paper tray or the bypass
tray.
9, 10
Original size not selected
automatically.
(When the SPF/RSPF is installed.)
Original(s) curled.
→ The original size cannot be correctly detected if the original is
curled or folded. Straighten the original.
–
The machine is directly exposed to sunlight.
→ Install in a location that is not exposed to sunlight.
–
Problem Cause and solution Page