Troubleshooting guide

56
CUSTOMISING SETTINGS (System Settings)
The system settings allow you to customise the machine to match your needs.
SYSTEM SETTINGS
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation
1 Auto clear time
1: OFF
2: 10 sec.
3: 20 sec.
4: 60 sec.
5: 90 sec.
6: 120 sec.
• "Auto clear time" automatically returns the
copy settings to the initial settings (p.8) when a
certain period of time elapses after a copy is
made. This program is used to select the
period of time. "Auto clear time" can also be
disabled.
2 Preheat mode
1: 1 min.
2: 5 min.
3: 30 min.
4: 60 min.
5: 120 min.
6: 240 min.
• This function automatically switches the
machine to a low power consumption state if
the set duration of time elapses without the
machine being used when the power is on.
The POWER SAVE indicator ( ) lights up,
however, the keys on the operation panel can
be used. Normal operation automatically
resumes when a key on the operation panel is
pressed, a print job is received or an original is
placed.
3
Auto power shut-off
timer
1: 5 min.
2: 30 min.
3: 60 min.
4: 120 min.
5: 240 min.
• This function automatically switches the
machine to a state that consumes even less
power than preheat mode if the set duration of
time elapses without the machine being used
when the power is on. All lights except the
POWER SAVE indicator ( ) and ON LINE
indicator go off. To resume normal operation,
press the [START] key ( ).
Normal operation also resumes automatically
when a print job is received. While in auto
power shut-off mode, no keys (except the
[START] key ( )) can be used.
4
Stream feeding mode
*1
0: OFF
1: ON
• When copying using the SPF/RSPF, during the
period of time that the SPF/RSPF indicator
blinks after an original has been scanned
(about 5 seconds), a subsequent original can
be placed and automatically fed into the
machine.
5
Auto power shut-off
setting
0: OFF
1: ON
• Use this setting to enable or disable auto
power shut-off.
6
Border line for 2 IN 1 /
4 IN 1
1: OFF
2: Solid line
3: Broken line
• When copying multiple originals onto a single
sheet of paper (2 IN 1 / 4 IN 1 copy), this
function can be used to print a solid or broken
borderline around each original image.
*
1
When the SPF/RSPF is installed.