Troubleshooting guide
Table Of Contents
- CONTENTS
- INTRODUCTION
- BEFORE USING THE MACHINE
- COPY FUNCTIONS
- PRINTER FUNCTIONS
- BASIC PRINTING
- PRINTER DRIVER SETTING SCREEN
- SETTING ADVANCED PRINT FUNCTIONS
- PRINTING MULTIPLE PAGES ON ONE PAGE (N-Up Printing)
- FITTING THE PRINTED IMAGE TO THE PAPER (Fit To Paper Size)
- ROTATING THE PRINT IMAGE 180 DEGREES (Rotate 180 degrees)
- ENLARGING/REDUCING THE PRINT IMAGE (Zoom)
- PRINTING FAINT TEXT AND LINES IN BLACK (Text To Black/Vector To Black)
- ADJUSTING THE BRIGHTNESS AND CONTRAST OF THE IMAGE (Image Adjustment)
- ADDING A WATERMARK TO PRINTED PAGES (Watermark)
- TWO-SIDED PRINTING (AR-5516D/AR-5520D)
- SAVING FREQUENTLY USED PRINT SETTINGS
- OUTLINE OF THE PRINT STATUS WINDOW
- SCANNER FUNCTIONS
- USER SETTINGS
- TROUBLESHOOTING
- ROUTINE MAINTENANCE
- PERIPHERAL DEVICES AND SUPPLIES
10
BEFORE USING THE MACHINE
LOADING PAPER
Make sure that the machine is not copying or printing, and then follow these steps to load paper.
Loading the paper tray
1
Gently lift and pull out the paper tray
until it stops.
2
Push the pressure plate down until it
locks in place.
Push the centre of the
pressure plate down until
it locks into place.
3
Load paper into the tray.
• Open the package of
the paper and load it
without fanning the
paper.
• Make sure the stack of
paper is straight before
loading it.
Make sure that the paper
fits under the tabs on the
right side of the tray.
4
Gently push the paper tray into the
machine.
• Do not load paper higher than the line on
the tray (up to 250 sheets).
• Do not add paper to the loaded paper. It
may cause multiple feed of paper.
• A5 can be used in the upper paper tray but
cannot be used in other trays (including
trays in optional paper feeding unit).
Note
• If you loaded a different size of paper than
was loaded previously in the tray, go to
"CHANGING A TRAY'S PAPER SIZE
SETTING" (p.12).
• When misfeed occurs, rotate the paper 180
degrees and reload it.
• Straighten curled paper before using it.
Note