Specifications

72
Network Settings (cont.)
-72
¤ Setting the SS ID
Set the projector’s SS ID.
The default setting is “SHARP_PRJ”.
Select “Wireless LAN” in the network
menu on the menu screen
➝ For operating the menu screen, see
pages 50 to 55.
1 Press
or
to select
“Wireless LAN” and then press .
2 Press
or
to select
“SS ID” and then press .
3 Press
or
to select
the characters you want to set.
Note
• The characters can be entered following:
Letters (A to Z), numerical (0 to 9),
symbols (–, _, ( ))
• Pressing
or
switches
between procedures as shown below.
• If you want to delete one character to the
left, select “BS” and press
.
4 Press
.
• You can also move the cursor using
on the GyroRemote.
Note
• If you want to correct a letter or symbol,
press
or
to move the cursor to the
character you want to correct, and then use
or
to correct the character.
•
If you want to cancel the settings, press
.
5 Repeat steps 3 and 4 to set all
the characters.
Note
• A maximum of 16 characters can be set.
6 Press
.
• The settings are enabled.