Projection Television User Manual

PAGE 11
INSTALLATION INSTRUCTIONS CEILING BRACKET AN-CM270
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
DIMENSIONS AND MEASUREMENTS OF COMPONENTS FOR
SHARP MOUNTING BRACKET AN-CM70
CEILING PLATE 4 ” WIDE X 18 ” LONG
DISTANCE BETWEEN SETS OF MOUNTING HOLES: 1st SET 12”, 2nd SET 14”, 3rd SET 16”
ADDITIONAL POSSIBLE COMBINATIONS OF MOUNTING HOLE DISTANCE 13” & 15”
THREAD SIZE OF SWIVEL SHAFT & CEILING PLATE BUSHING 1/2” X 20
15
”
4”
12”
14”
16”
18”
VEL-
VEL-
CABLE ACCESS HOLE
CENTER BUSHING 7/8” DEEP
1/2X20 THREADED HOLE
A. From ceiling to inverted bottom of projector: 5 1/2”
B. Length of position adjustment knuckle assembly: 3 1/2”
C. Lens offset from center of lens to center of mounting bushing: 3”
D. Ceiling to center of lens: 7”
E. Ceiling to top of inverted projector: 8 7/8”
F. Mounting screws M4 X 12 & 30 mm long metric flat head phillips.
ATTACHMENT PLATE WITH POSITIONING ASSEMBLY:
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE