User Manual

2929
2929
29
SUPPLIES AND USER MAINTENANCE
4
4.4.
4.4.
4.
SUPPLIES AND USER MAINTENANCESUPPLIES AND USER MAINTENANCE
SUPPLIES AND USER MAINTENANCESUPPLIES AND USER MAINTENANCE
SUPPLIES AND USER MAINTENANCE
TD cartridge replacementTD cartridge replacement
TD cartridge replacementTD cartridge replacement
TD cartridge replacement
Be sure to use only genuine SHARP parts and supplies.
The TD cartridge replacement required (
s
) indicator will light up when toner is
needed. For more information on purchasing the TD cartridge, see SUPPLY LIST
on page
126. If copying is continued while the (
s
) indicator is lit, copies will gradually
become lighter until the copier stops and the indicator begins blinking.
Replace the old TD cartridge by following the procedure given below.
Do not turn off the machine power when replacing the TD cartridge. Doing
so will clear any facsimile or print data that has been stored in memory.
1
2
Push gently on both sides of the front cover to open the cover.
• After the copier stops, it may be possible to make a few more copies
by taking the TD cartridge out of the copier, shaking it horizontally, then
reinstalling it. If copying is not possible after this operation, replace the
TD cartridge.
• If the indicator begins to blink while facsimile data is being received,
the data will not be printed and will be stored in memory. After the TD
cartridge is replaced,the data that has been stored in memory will be
automatically printed.
Gently pull the TD cartridge handle out by inserting your fingers into the
groove at the center of the handle.
SUK 04 SUPPLIES AND USER MAINTENANCE LEO.p65 17/04/00, 10:5529