Service manual

AL-2051 USER PROGRAM 11 - 3
2. Selecting a setting for a user program
1) Press the [MENU] key and then press the [OK] key.
In printer mode, the user programs are accessed by simply
pressing the [MENU] key.
2) Press the [ ] key ( ) or [ ] key ( ) to select the item
that you wish to configure in the USER PROGRAM items, and
then press the [OK] key.
• See "USER PROGRAM" for the program name and program
code.
• You can also select a program by directly entering the pro-
gram number with the numeric keys.
3) Press the [ ] key ( ) or [ ] key ( ) to change the set-
ting of the selec ted item.
See "USER PROGRAM" for the program code.
Note:
• If you mistakenly select the wrong item, press the [CLEAR]
key ( ) and repeat the procedure from step 2.
• To cancel a setting for a user program, press the [MENU] key.
4) Press the [OK] key.
Your selection appears briefly and then the previous screen
appears.
Note: When "AE LEVEL ADJUST" is selected in the user
programs and the [OK] key is pressed, the automatic
exposure adjustment screen appears. Adjust the
exposure and press the [OK] key.
Audible signals (key entry beep, invalid key beep, base setting
beep)
The machine sounds three different types of beep signals: a key
entry beep that sounds when a valid key is pressed, an invalid key
beep that sounds when an invalid key is pressed, and a base setting
beep that sounds when a setting is the same as the base setting
(base settings are explained below). The base setting beep is ini-
tially disabled.
The beep patterns of each type of beep signal are as follows:
Key entry beep: One beep
Invalid key beep: Two beeps
Base setting beep: Three beeps
Base settings
The base settings are preset standard selections for each copy set-
ting. The base settings are as follows:
Copy ratio: 100%
Light and Dark level: Center
Paper feed location: Paper tray
AUTO/TEXT/PHOTO: AUTO
MAIN MENU
1:USER PROGRAM
USER PROGRAM
2:PREHEAT MODE
PREHEAT MODE
2:1 MIN