Service manual

AL-2030/2040CS/2050CS SIMULATION, TROUBLE CODES 10 - 11
25 10 Polygon motor ON [Function]
When [ENTER]/[START] key is pressed, the Bios is called to rotate the polygon motor for
30sec.
After completion of 30sec operation, the operation is turned off with the Bios and the machine
goes into the sub code entry standby mode.
[Operation] (AL-2050CS only)
26 02 SPF/RSPF setup [Function]
When this simulation is executed, the current set SPF/RSPF is displayed. Enter the code num-
ber corresponding to the desired SPF/RSPF and press [ENTER]/[START] key to save the set-
ting.
[Operation]
03 Second cassette setup [Function]
When this simulation is executed, the current set second cassette is displayed. Enter the code
number corresponding to the desired second cassette and press [ENTER]/[START] key to save
the setting.
[Operation]
The operation is similar to simulation 26-02.
04 Machine duplex setup [Function]
When this simulation is executed, the current set duplex is displayed. Enter the code number
corresponding to the desired duplex and press [ENTER]/[START] key to save the setting.
[Operation]
The operation is similar to simulation 26-02.
06 Destination setup [Function]
When this simulation is executed, the current set destination is displayed. Enter the code
number corresponding to the desired destination and press [ENTER]/[START] key to save the
setting.
* Code number 2 cannot be selected.
[Operation]
The operation is similar to simulation 26-02.
Main
code
Sub
code
Contents Details of function/operation
1) Initial display
25-10 LSU CHK
EXECUTING...
Code number SPF/RSPF Display item
0SPF NO SPF OFF
1 SPF YES SPF ON
2 RSPF YES RSPF ON
AL-2050CS
1) The current set value is
displayed.
2) [Numeric] key or [ ] key
2) [Numeric] key or [ ] key
3) [ENTER]/[START] key
AL-2030/2040CS
1) Press [ ] [ ] key to
change the code number.
2) Press [START] key to fix
the code number.
26-02 SPF/RSPF
1:SPF ON (0- 2)
26-02 SPF/RSPF
0:SPF OFF (0- 2)
26-02 SPF/RSPF
2:RSPF ON (0- 2)
26-02 SPF/RSPF
2:RSPF ON (0- 2)
Code number Second cassette Display item
0 Second cassette NO OFF
1 Second cassette YES ON
* AL-2030: cannot be executed.
Code number Duplex Display item
0 Duplex NO OFF
1 Duplex YES* ON
Code number Destination Display item
0 Inch series INCH
1 EX Japan AB series AB
2 Japan AB series –