Service manual

AL-2030/2040CS/2050CS DISASSEMBLY AND ASSEMBLY 8 - 20

(2) Paper exit roller removal

1) Remove the E-ring.

2) Slide the bearing.

3) Remove the paper exit roller.

4) Remove the E-ring.

5) Remove the bearing.

F. Drive unit

(1) Transport unit removal

1) Disconnect four connectors.

2) Remove the harness from the clamp.

3) Remove the snap band.

4) Remove one screw.

5) Remove the earth wire.

6) Remove one screw.

7) Disconnect the RSPF harness.

8) Remove four screws.

9) Remove the transport unit.

■ Note for reassembly

Before assembly, be sure to check that the harness is passed

through the rib.

Arrange the RSPF harness to the outside of the base tray so that it

is nit pinched before assembly.

(2) Drive unit removal

1) Remove three screws.

2) Remove the drive unit.

(3) Drive motor removal

1) Remove the gear.

2) Remove two screws.

3) Remove the drive motor.

■ Note for reassembly

Connect the connectors according to the arrow indication marked

on the motor mounting plate.