Service manual

AL-2030/2040CS/2050CS UNPACKING AND INSTALLATION 5 - 14

12) Attach the Scanner UPG mylar J3 to cover the hole on the right

side of inside of the scanner.

Note: The mylar should cover the hole shown by the arrow in

the diagram.

Attach along with the bent part of the metal plate and align the

edge of the mylar with the line shown in the diagram (the yellow

line in the diagram).

13) Attach the Fan housing cushion to the cooling fan at the posi-

tion shown in the diagram below.

Cover the top and the right side of the fan housing when you

see the fan housing from the backside of the machine.

Note: Please make sure the double-sided tape is not exposed

where the cushion is sticking out from the edge of the fan

housing.

Attach the cushion leaving 3 - 7mm from the edge so that the

gap between the Fan housing cushion and the filter of the rear

cabinet is filled for sure.

14) Attach the parts removed in the items 1), 2), and 3).

Viewfrom

the arrowA

Back side

Attach the cushion leaving3-7mm

from the edge.

Reference position

3 - 7mm