Specifications

AL-1551 SIMULATION, TROUBLE CODES 10-7
26 42 Transfer ON timing control setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed. (For any number different from the following ones,
the default time is automatically set.)
43 Side void setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of the side void amount is displayed.
2. Enter the code number and press the start key. The setting is changed.
44 SPF document rear edge read setup + Fax document rear edge scan setup.
When this simulation is executed, the currently set code number is displayed. Enter the desired code number and press the START key,
and the display will be changed. The document rear edge scanning area in SPF reduction (less than 100%) copy is changed.
The code number is changeable in the range of 0 - 8.
The default value is 4, and 2 mm of the document rear edge is cut.
When the value is changed by 1, the area is changed by 1 mm.
30 01 Paper sensor status display
The paper sensor status is displayed with the lamps on the operation panel.
Main
code
Sub
code
Content
Code number Setting
0 Default (330 msec)
1 -40 msec
2 -30 msec
3 -20 msec
4 -10 msec
5 Default (330 msec)
6 +10 msec
7 +20 msec
8 +30 msec
9 +40 msec
Code number Setting
00 mm
10.5 mm
21.0 mm
31.5 mm
4 2.0 mm *Default
52.5 mm
63.0 mm
73.5 mm
84.0 mm
94.5 mm
10 5.0 mm
Display Sensor
Developer cartridge replacement lamp Paper detection before resist (PPD1)
JAM lamp Fusing section paper detection (PPD2)
Photoconductor cartridge replacement lamp Paper exit paper detection (POD)
2nd cassette lamp 2nd CS paper detection (PPD3)
Zoom lamp New drum cartridge detection (PUIS)
AE lamp Single manual feed paper detection (MFD)
Exposure level 1 (Light) lamp Main cassette A4 width detection (PSW1)
Exposure level 5 (Dark) lamp 2nd cassette A4 width detection (PSW2)