Specifications

AL-1551 SIMULATION, TROUBLE CODES 10-2
2. List of simulations
Sim No. Kind of
main code
Sub
code
Operation
01 Optical system 01 Mirror scan operation
02 SPF Individual
load operation
02 SPF sensor status display
03 Motor ON
04 Paper feed solenoid ON
05 Pressure release solenoid ON (RSPF)
06 Resist clutch ON (RSPF)
07 Gate solenoid ON (RSPF)
05 Lamp ON
check
01 Operation panel display check
02 Fusing lamp ON + Cooling fan
HIGH/LOW speed
03 Copy lamp ON
06 Machine
individual load
operation
01 Paper feed solenoid ON
02 Resist solenoid ON
07 Aging 01 Warm up display and aging with jam
06 Intermittent aging
08 High voltage
output check
01 Developing bias
02 Main charger (Grid high)
03 Grid voltage (Low)
06 Transfer charger
10 Other None Toner motor aging
14 Trouble reset None Cancel troubles other than U2
16 U2 trouble
reset
None Cancel of U2 trouble
22 Counter
display
05 Total counter display
12 Drum counter display
14 P-ROM version display
21 Scanner counter display
24 Special
counter clear
07 Drum counter clear
13 Scanner counter clear
25 Main motor
ON
01 Main motor system ON + Cooling fan
low speed
(For the duplex model, the duplex
motor is simultaneously turned on.)
10 Polygon motor ON
26 Various setup 01 Manual feed setup
02 SPF setup
03 Second cassette setup
04 Machine duplex setup
06 Destination setup
07 Machine conditions check
20 Rear edge void setup
30 CE mark conformity control
ON/OFF setup
38 Cancel of stop at drum life over
39 Memory capacity setup
40 Polygon motor OFF time setup
42 Transfer ON timing control setup
43 Side void setup
44 SPF document rear edge read setup
30 Sensor
operation
check
(Standard
provision)
01 Paper sensor status display
43 Fusing
temperature
setup
01 Normal copy
04 Fusing temperature setup 2
05 Duplex mode fusing temperature setup
46 Exposure
adjustment
01 Copy density adjustment
48 Magnification
ratio correction
01 Front/rear scan direction
50 Lead edge
adjustment
01 Lead edge image position adjustment
Paper lead edge/rear edge void
adjustment
10 Paper center offset +
OC/Document center offset +
SPF document center offset
18 Memory reverse position adjustment
19 Duplex copy rear edge void adjustment
51 Timing
adjustment
02 Resist quantity adjustment
06 SPF exposure correction
61 Laser system
operation
03 Polygon motor check
(HSYNC output check)
63 Shading 01 Shading check
64 Self print 01 Self print only with the engine
(1 by 2 mode)
Sim No. Kind of
main code
Sub
code
Operation