Specifications

MX-3610N SIMULATION 5 – 115
50-10
Purpose
Adjustment
Function (Purpose)
Used to adjust the black print image magni-
fication ratio and the off-center position.
(The adjustment is made separately for
each paper feed section.)
Section
Operation/Procedure
1) Select an adjustment target item with scroll key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [EXECUTE] key. (The set value is saved.)
Item A: When the set value is increased, the BK image magnification ratio in the main scanning direction is increased. When the set value is
decreased, the image magnification ratio is decreased.
Item B - H: When the adjustment value is increased, it is shifted to the front frame side. When the adjustment value is decreased, it is shifted to
the rear frame side.
All adjustment items: 1 step = 0.1mm change
50-12
Purpose
Adjustment
Function (Purpose)
Used to perform the scan image off-center
position adjustment. (The adjustment is
made separately for each scan mode.)
Section
Operation/Procedure
1) Select an adjustment target item with scroll key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [OK] key. (The set value is saved.)
When the adjustment value is increased, the image position is
shifted to the rear frame side. When the adjustment value is
decreased, it is shifted to the front frame side.
1step = 0.1mm
Item/Display Content Setting range Default value NOTE
A BK-MAG Main scan print magnification ratio BK 60 - 140 110 Adjustment Item List
B MAIN-MFT Print off center adjustment value (Manual paper feed) 1 - 99 50
C MAIN-CS1 Print off center adjustment value (Tray 1) 1 - 99 52
D MAIN-CS2 Print off center adjustment value (Tray 2) 1 - 99 52
E MAIN-CS3 Print off center adjustment value (Tray 3) 1 - 99 52
F MAIN-CS4 Print off center adjustment value (Tray 4) 1 - 99 52
G MAIN-LCC Print off center adjustment value (Large capacity tray) 1 - 99 52
H MAIN-ADU Print off center adjustment value (Duplex)
If the adjustment items A - G are not properly adjusted, this
adjustment cannot be executed properly.
1 - 99 42 Adjustment Item List
I SUB-MFT Registration motor ON timing
adjustment
Manual paper feed 1 - 99 60
J SUB-CS1 Standard cassette 1 - 99 60
K SUB-DSK DESK 1 - 99 60
L SUB-LCC LCC 1 - 99 60
M SUB-ADU ADU 1 - 99 60
N MULTI COUNT Number of print 1 - 999 1 Adjustment pattern print
conditions setting
O PAPER MFT Tray selection Manual paper feed 1 - 6 1 2 (CS1)
CS1 Tray 1 2
CS2 Tray 2 3
CS3 Tray 3 4
CS4 Tray 4 5
LCC LCC 6
P DUPLEX YES Duplex print selection Yes 0 - 1 0 1 (NO)
NO No 1
Item/Display Content
Setting
range
Default
value
A OC Document table image off-
center adjustment
1 - 99 50
B SPF (SIDE1) SPF front surface image off-
center adjustment
1 - 99 50
C SPF (SIDE2) SPF back surface image off-
center adjustment
1 - 99 50