Specifications

4. Composing and Focusing
While viewing through the finder, turn the focusing ring until your subject
comes into sharp focus and choose the most pleasing composition.
5. Turn on Exposure Meter and Rotate Aperture Ring
Pull out the rapid-wind lever slightly (20°) and depress the shutter release
button halfway to turn on the exposure meter. The preselected shutter speed
plus the two adjacent speeds ("60" and
"250" in the case of "125") are visible on the right-hand side of the viewfinder.
Turn the aperture ring until the central green LED dot glows which indicates
proper exposure. (The f-stop you have selected is also visible in the small
window above the focusing screen). If the central green dot does not glow no
matter how far you turn the aperture ring, change the shutter speed.
6.Release Shutter
Hold your camera firmly and trip the shutter. Then cock the rapid-wind lever
for the next picture. (As long as the lever is at its pre-advance angle, the light
meter stays ON. If you push it back to the completely closed position, the
meter is turned OFF.)
FILM LOADING AND WINDING SETTING ASA FILM SPEED
1. Open the back by pulling up the
rewind knob until the back opens.
2. Place the film cartridge in the film
chamber, and push down the rewind
knob. Insert the film leader in between
any of the white plastic pins
surrounding the film take-up spool.
3. Advance the film by alternately
advancing the rapid wind lever and
depressing the shutter button until
both top and bottom sprockets engage
the film perforations. Close the back
by pressing it firmly.