Operation Manual

E-12
MAINTENANCE AFTER AIR
CONDITIONER SEASON
1
Operate the unit in the SELF CLEAN
operation to allow the mechanism to
thoroughly dry.
2
Stop the operation and unplug the unit.
Turn off the circuit breaker, if you have
one exclusively for the air conditioner.
3
Clean the fi lters, then reinstall them.
MAINTENANCE BEFORE AIR
CONDITIONER SEASON
1
Make sure that the air fi lters are not dirty.
2
Make sure that nothing obstructs the air
inlet or outlet.
3
Check the outdoor mounting rack
periodically for wear and to make sure it
is fi rmly in place.
CHANGING THE AIR PURIFYING
FILTER
The fi lters should be changed every 3 ~ 6 months
1
Remove the air fi lters.
2
Change the air purifying fi lters.
1
Take off the old air purifying fi lters from the
air fi lters.
2
Set the new air purifying fi lters, under the
fi lter stoppers located on the air fi lters.
3
Reinstall the air fi lters.
NOTE:
• The dirty air purifying fi lters are not washable for
reuse. The new fi lters are available at your nearest
dealer.
Replacement fi lter: Type AZ-F900F
Disposal of Filters
Please dispose of replaced fi lters according to the
local disposal laws and regulations.
AIR PURIFYING fi lter materials
Filter:Polypropylene
Frame:Polyester
MAINTENANCE
Be sure to disconnect the power cord from the
wall outlet or turn off the circuit breaker before
performing any maintenance.
CLEANING THE FILTERS
The air fi lters should be cleaned every two weeks.
1
Turn off the unit.
2
Remove the fi lters.
1
Lift the open panel.
2
Push the air fi lters up slightly to unlock them.
3
Pull the air fi lters down to remove them.
3
Take off the air purifying fi lters from the
air fi lters.
4
Clean the fi lters.
Use a vacuum cleaner to remove dust. If the
fi lters are dirty, wash them with warm water and
a mild detergent. Dry fi lters in the shade before
reinstalling.
5
Reinstall the air purifying fi lters.
6
Reinstall the fi lters.
1
Reinstall the fi lters in the original positions.
2
Close the open panel.
3
Push the arrow-marked of the panel fi rmly to
lock it in place.
CLEANING THE UNIT AND THE
REMOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It can
cause electrical shock or equipment damage.
• Do not use hot water, thinner, abrasive powders or
strong solvents.
Filter stopper
3
2
1
1
3
2