Specifications

91
Driver-Controlled Main Differential Lock
MAINTENANCE MANUAL
NOTE:
Some models use silastic seal instead of
theatwasherinStepE.Also,arollpinis
installed in the shift shaft and is used as a
stop for the shift shaft spring. It is not nec-
essary to remove this roll pin during a nor-
mal disassembly.
E. Removetheshiftshaftspringandatwash-
er.
F. Remove the shift fork and continue with Step
11 in the previous procedure.
DCDL Installation
Differential Shift Assembly
WARNING
When you apply some silicone gasket materials, a
small a mount of acid vapor is present. To prevent
seriouspersonalinjury,ensurethattheworkarea
is well-ventilated. Read the manufacturer’s instruc-
tions before using a silicone gasket material, then
carefully follow the instructions. If a silicone gasket
material gets into your eyes, follow the manufac-
turer’s emergency procedures. Have your eyes
checked by a physician as soon as possible.
Take care when you use Loctite® adhesive to
avoidseriouspersonalinjury.Readthemanufac-
turer’s instructions before using this product. Fol-
low the instructions carefully to prevent irritation to
the eyes and skin.
Threaded DCDL Shift Assembly.
Install the differential shift assembly after the dif-
ferential is assembled and the gear and bearing
adjustmentsaremade.TheThreadedDCDLshift
assembly is shown in Figure 6.15
1.Install the shift fork into the shift of the dif-
ferential. The “L” shape of the fork and the
bore for the shift shaft must face out toward
the cylinder bore in the side of the differential.
Figure 6.16.
CAPSCREW AND WASH-
ER, FOUR CORNERS
TAPA, JUNTA DE COBRE
debajodelatapa-sólo
Serie 160
Figure 6.14
THREADED VERSION UNLOCKED
SHIFT SHAFT AND
SPRING
RING GEAR
SHIFT FORK
O’RING
CILYNDER
PISTON
ELETRIC CONNECTION
FOR SENSOR
POSITION FIXING
SCREW GEAR
Figure 6.15
LOCKED
“L” SHAPE OF
FORK
FACE OUT
Figure 6.16