Specifications

Removal and Disassembly
22 MAINTENANCE MANUAL
B. Place the assembly on a press so that ex-
traction tool it rests on the differential. Figure
3.34.
C. Place a protector on top of the input shaft.
Remove the input shaft from the assembly.
Remove the extraction tool. Figure 3.34.
D. Remove the capscrews that fasten the oil pump
to bearing cage fron the input shaft. Separate
the oil pump from the cage. Figure 3.35.
7. Remove the O-rings from the bearing cage
of the input shaft and, if used, the oil pump
assembly
8. Remove the cone from the input bearing cage.
NOTE:
If you replace either the bearing cup or the
cone, replace both parts in a fully-matched
set from the same manufacturer.
9. If necessary, use a press and sleeve to re-
move the cup from the input bearing cage of
the input shaft.
10. If necessary, remove the pressure relief
valve assembly from the front of the bearing
cage. Remove the plug, spring and relief
valve from the bore. Figure 3.36.
11. Remove the oil screen and plug assembly
from the suction line at the front of the cage
of differential assembly. Figure 3.37.
12. Clean the oil screen. See section 4.
E. If the pump is worn or damaged, replace the
pump.Ifthedriveatsorthesplinesinthe
pump do not move, replace the pump.
Figure 3.34
Figure 3.35
EXTRACTION
TOLL
OIL PUMP
PROTECTOR
PRESS
BEARING CAGE
OIL PUMP
BEARING CONE
RELIEF
VALVE
Figure 3.36
PLUG OLDER
MODELS ONLY
SPRING
RELIEF VALVE
Figure 3.37
BEARING CAGE